Caught in running equipment or machinery during regular operation · Cuts, lacerations
At a glance
Federal OSHA recorded a severe workplace injury
at MERRIMAC SPOOL & REEL CO., INC., 203 ESSEX STREET, HAVERHILL, MASSACHUSETTS 01832
on — Cuts, lacerations, affecting the finger(s), fingernail(s), unspecified.
Final narrative
An employee was operating an industrial stapling machine and was wiping excess oil off of the tip of the machine when the machine stapled/lacerated a finger.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 322214)
An employee was using sandpaper to sand a mandrel on a re-cutter. The sandpaper snagged on the mandrel and pulled the employee's gloved right hand into the machine. The hand was amputated and the skin was torn off up to the elbow.
At approximately 1:00 a.m., on 7/15/2019, a machine operator was performing a maintenance procedure on a board press. The operator was connecting a wire when a cog (wheel) grabbed her right hand and damaged the tissue between the thumb and index finger and knuckles.
An employee was attempting to remove a metal lid that had been stamped and was stuck in a punch press die when the press was activated via the foot pedal, causing it to cycle and sever his left hand.
An employee was operating a re-cutter machine and turned it off to remove a piece of trim from the mandrel. The machine was not fully stopped before he began to remove the trim and the moving parts contacted his left hand, resulting in a partial left index finger amputation.
An employee fell while exiting a trailer. The employee landed on their left side on the pavement, suffering multiple broken ribs on the left side. The employee was hospitalized.
Two employees were setting up a mandrel in the spindle of a machine. The mandrel was side-shifted while an employee's hand was on the mast of a powered industrial truck. The employee suffered crushing injuries that resulted in amputations to the middle and ring fingertips.
An employee had been loading a double deck press. The employee saw a mold had been sent in with the C-hook still attached on the belly bar. As he went to remove the hook from the mold, his right thumb got caught on the C-hook. The employee's thumb was partially amputated.
An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.
An employee was delivering home heating fuel when bees came from the ground and stung the employee's face, neck, torso, and hands. The employee proceeded to shut off the oil flow before losing consciousness. They were hospitalized due to an anaphylactic reaction.