Small-scale (limited) fire · Second degree heat (thermal) burns
At a glance
Federal OSHA recorded a severe workplace injury
at Beasley Timber Co. Inc., 712 UVALDA HWY, HAZLEHURST, GEORGIA 31539
on — Second degree heat (thermal) burns, affecting the neck, except internal location of diseases or disorders.
Watch Beasley Timber Co. Inc. — freeGet an email when a new federal OSHA severe-injury report for Beasley Timber Co. Inc. is published. One employer, no account, unsubscribe in one click.
Final narrative
An employee was standing near a debris burn pile at a work site when a combustion in the burn pile occurred, resulting in second degree burns to their neck.
HospitalizedNeck, except internal location of diseases or disordersScrap, waste, debris, unspecified
An employee was banding lumber together. A forklift approached, carrying twin packs of lumber on its forks. When it stopped, the lumber packs slid forward and pinned the employee between two packs of lumber, breaking his hips.
An employee was driving a front-end loader from one yard to another when the engine shut off, leaving him with no power to control it. He jumped clear of the loader and broke his left leg when he hit the ground.
An employee was standing on a bag of bentonite clay composite when it ignited and the employee's pants leg caught on fire. The employee then went to remove a gasoline can from a dual-axle trailer and sustained burns to his arms, right hand, and the right side of his abdomen.
Two employees were working on an empty above-ground 2,500-barrel crude oil tank. Employee 1 was welding while employee 2 was watching. Employee 1 saw fire behind the welding smoke and notified employee 2. Before they could get off the tank, they both fell in the tank and sustained burns from the fire.
An employee was pressing pyrotechnic composition into pellets using a pressure tablet press. Upon pouring the composition into the small hopper, the composition ignited and produced a flash fire. The employee sustained bilateral burns to the hands and face.
More severe injuries in this industry (NAICS 321113)
An employee was repairing a photo eye on the infeed roll case when they dropped a tool. The employee went to grab the tool and his fingers contacted the chain and sprocket of the infeed roll case. His fingers were pulled into the pinch point and the fingertips were crushed, resulting in amputation of one fingertip.
An employee was troubleshooting dispersing equipment. A belt and pulley system was energized, and the moving belt caught the employee's right ring finger. He suffered a partial amputation at the first knuckle, below the nail.
An employee was cleaning the photo eye sensors of a piece of equipment between the saw that cuts lumber into lengths and boards. The employee stepped on a metal grate that gave way and fell 8-10 feet. The employee was able to remove himself from the conveyor. His tibia was fractured just below the knee.
While refilling a lubricant tank, an employee observed that a pump was not operating correctly. While troubleshooting the issue, the employee reached toward the back of the pump to check for proper airflow. Their left index finger contacted moving components in the pump's piston mechanism, resulting in partial amputation of the fingertip.
An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.
During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.