Versant Power

Two employees were checking electrical reclosers. During the testing, an energized bushing came into contact with one of the employees, touching his left bicep and the top of his chest on the left side and causing a shock and a burn. He was hospitalized.

On November 9, 2023, an employee lifted a 70-pound package of paper bags, put it in a cart, and then pushed the cart to the front of the store by the cash registers. The employee sustained a collapsed lung.

An employee was providing medical treatment to injured persons involved in a motor vehicle accident. The employee was walking up and down a low-grade embankment carrying injured persons on transport equipment such as backboards. The employee sustained chest pain, and a possible cardiac related event with an elevated heart rate and elevated blood pressure.

An employee was moving merchandise in boxes, rolling containers, and totes, from a truck to store shelves when they sustained back and neck injuries.

An employee was using a shovel to dig a hole for a pipe when he suffered a broken vertebra. He was hospitalized.

On June 16, 2023, an employee was elevated in a scissor lift and was removing a pipe from a structure when they began experiencing back pain. The employee sustained a ruptured abdominal aneurysm from lifting/carrying/pulling pipe.

An employee was setting up communication equipment for a meeting. They were walking and tripped over a speaker on the ground. The employee sustained a leg injury.

An employee (a lineman) was working to restore power by installing a hand line when he contacted a high-voltage device (7,200 volts), resulting in electrical burns to his upper body and hands.

A chain sling failed while a utility pole was being removed. A chain link struck an employee who was operating a front-end loader, puncturing the employee's chest.

An employee was working with an underground crew to troubleshoot a BUD failure. The employee was removing a fuse from the fuse holder when the fuse blew on the riser and an arc flash occurred. The employee was hospitalized with burns to his face, nose, lips, and neck.

An employee was connecting two wires when his rubber insulated gloves failed and he suffered an electric shock to his right hand, resulting in an electrical burn.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.

An employee was using a metal shear when it amputated the tip of his right index finger.

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.