Energy Transfer

An employee was monitoring the excavation of a 30-inch valve and the pipeline pressure. The employee started getting light-headed, short of breath, and hot. The employee was hospitalized with dehydration.

A mechanic working for Energy Transfer was trying to insert a compressor piston when it amputated his right middle fingertip.

An employee was loading a pallet into a truck when he slipped and tore his left patella tendon, requiring hospitalization.

An employee was working on the engine of a compressor when a flash fire occurred, burning the employee's hands and face. He was hospitalized.

Employees were performing construction work on an esplanade. Three employees were retrieving float stages that were secured alongside a barge and taking them approximately 150' North to a second barge. The float stages were to be loaded with forms and sent under the esplanade to be installed. In order to retrieve the float stages the operation required a boat to pull back the floats to release the tension in the lines (2 each, one at the North end and one at the South end of the floats) due to the flood tide. The boat was positioned South of the float stages. Two employees left the boat and boarded the floats. They tied a line from the boat to the float stages and moved to the lines securing the floats to the barge. One employee was on the South end of the float stages and a second employee was on the North side, each at a line. When the tension was released by the boat, both employees released each line. The platform was also released from the boat to allow for the boat's navigation around some piles. They floated North on the float stages. Once the float stages moved beyond the end of the barge, the float stages turned 90 degrees and were pointing In an east to west orientation, broadside to the current. Once broadside to the current, the current took them North causing them to strike the South end of the barge approximately 150' away. The two employees attempted to push the float stages away from the barge, but were unable to. At this time the third float stage started lifting and pushing the second float stage into the first float stage. The first float stage was pushed in the up and down position (90 degrees vertically with the flat side against the barge) and pinned against the barge, the second float stage came to rest on the first float stage side horizontally (parallel to the water), and the third float stage was also turned and was pushing on the backside of the second float stage. The injured employee's legs were pinned between a float stage (20' x 5') made of timbers and the barge with a steel hull (180' x 60'), resulting in a right tibia and fibula fracture and a left fibula fracture.

An employee was working from a floating platform to remove a concrete form when a wave in the water caused the platform to rise up above the protective bumpers. His left little finger was then caught between the formwork bolt and the platform, causing a partial amputation of the left little finger.

An employee was in a boat traveling back to a dam when the boat passed through an opened gate. The boat became caught on the gate and tipped over. The employee went underneath the water and suffered an amputation to 1/4 inch of the distal joint of the left ring finger.

Between around 4:30 and 4:45 p.m., two employees were motoring a skiff down a river when the skiff hydroplaned and struck the shoreline. The employees were both injured: one suffered upper body injuries (suspected broken ribs) and a concussion and the other suffered facial and leg injuries. Both were hospitalized.

An employee was in a boat, inspecting a pipeline, when the boat hit something in the water and ejected the employee from the seat. The employee hit the boat floor and suffered a forehead laceration and fractured left wrist.

An employee was walking when he tripped on a small mound of dirt, fell, and sustained a fractured leg.

An employee was polishing the center of a try bar on a lathe when they sustained an avulsion of the right forearm that required surgery.

An employee was operating a dump truck when the trailer door swung and pinched the employee's right middle fingertip underneath the nailbed, resulting in an amputation.

An employee worked all day outside and started cramping. The employee was hospitalized for heat-related illness.

An employee was attaching a turnbuckle to an auger. The turnbuckle slipped and the employee's left thumb was pinched between the turnbuckle and the auger resulting in a partial amputation of left thumb.

A driver was exiting his vehicle outside the plant gate when his foot slipped on the top step of the truck. He fell to the ground, landed on his left hip and elbow. The employee was hospitalized with a fractured hip/femur.

A security employee was responding to an urgent call from staff regarding a violent patient. The employee tripped and fell on the floor outside of the stairwell. The employee sustained a closed head injury, contusion of the cerebrum without loss of consciousness, and a closed fracture of the distal end of the right radius.

A security employee was holstering her firearm when the gun discharged a bullet into her right leg. The employee was hospitalized.

A temporary employee was testing an electrical starter motor. He was placing tape on the starter while the breaker was not engaged, but the starter sent an arc flash that burned his hands and stomach.

An employee was walking on a sidewalk and stubbed his toe on an elevated portion of concrete, causing him to trip and fall. The employee's right knee was dislocated.