Eldredge Lumber and Hardware, Inc

An employee had climbed onto the top of a one-unit lumber truck to strap down the load. When coming down the side of the truck, he lost his footing and fell to the ground, suffering a concussion, a broken rib, and a facial fracture.

An employee was walking in an aisle when a forklift backed up over her foot, resulting in a skin injury that required surgery to repair.

An employee was looking into the bucket of a front-end loader to see how much material was in it. A skid steer backed into the employee, who then fell into the edge of the front loader's bucket and suffered internal bleeding in the abdominal area.

An employee was spotting for a forklift operation. The forklift backed over the employee, who suffered a complete amputation to one lower leg and a partial amputation to the other leg. The employee was hospitalized.

An employee was cleaning his work area and preparing it to begin making air-set molds when a nearby forklift that was backing out from a load swung around and struck the employee. They sustained a lower left leg fracture.

An employee was walking around a work area when he was struck by a forklift that was backing up, resulting in several broken bones in his foot.

The injured employee was walking through the warehouse. Another associate was driving a forklift with a pallet of large format tile (slabs) when the slabs began to tip. The injured employee ran over to stop the slabs from falling, but the slabs fell on his lower left leg/foot. The employee sustained fractures in his lower leg and foot. He was hospitalized and required surgery.

An employee was doing a cutback on a piece of lumber using a chop saw. The saw hit a knot, the piece of lumber buckled, then kicked back and broke the kickback guard. The board was then pulled back into the blade, which lacerated the employee's left index and middle fingers.

On October 16, 2025, an employee was entering a parking lot after completing their work shift when they were struck by a vehicle being operated by a customer. The employee fell backward from the impact and the back of their head struck the asphalt. The employee was hospitalized due to brain bleed and a skull fracture.

An employee was descending a rolling ladder when she fell from the last step and her head struck the floor, resulting in a fractured pelvis.

On September 24, 2025, an employee was using a sledgehammer to straighten the forks on a forklift when a piece of metal broke off the fork and became lodged in the employee's leg. The employee was hospitalized.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.

An employee was using a metal shear when it amputated the tip of his right index finger.

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.