ABB Motors and Mechanical Inc.

An employee was carrying a metal plate (18 inches x 18.75 inches) when it dropped onto his right foot, resulting in a fracture.

An employee was operating a coil winding machine when the distal tuft of their left middle finger was caught under wire, resulting in an amputation to the fingertip.

An employee was changing a saw blade when the saw machine activated. The employee's left ring and little fingers were amputated.

An employee was clearing a jam from the label cutting machine when their left middle finger was partially amputated.

Two employees were repairing the hydraulic engagement pins on a rented front-end wheel loader. The machine controls were activated to move the attachment pins and an employee's finger was caught between the pins and the bushings. Their right index finger was partially amputated.

An employee was cleaning the conveyor on a piece of equipment when they slipped and their right hand was pulled into the chain sprocket. The employee's fifth fingertip was amputated.

An employee was throwing blankets onto a blanket folding and stacking machine. A blanket got stuck in the machine and she attempted to remove it when the machine contacted her right little finger, resulting in a fingertip amputation.

An employee was cleaning a machine and bleeding its lines. After the gauge read 0, the employee removed the metal lid covering a filter. The lid popped off and struck the employee in the face, causing a broken nose, a broken jaw, and lacerations.

An employee was burned by an arc flash that occurred in an electrical room.

An employee was carrying a metal plate (18 inches x 18.75 inches) when it dropped onto his right foot, resulting in a fracture.

An employee was troubleshooting a variable frequency drive (VFD). There was an electrical discharge. The employee experienced an electrical shock of approximately 480 volts and sustained second- and third-degree burns on their right hand, wrist, forearm, and elbow.

An employee was operating a press and sustained broken bones in the right hand.

An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.

On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.

An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.

An employee was helping two other employees to push a pallet of tile on a loading dock. He suffered a broken fibula and was hospitalized.

On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.