Other fall to lower level 6 to 10 feet · Fractures and burns
At a glance
Federal OSHA recorded a severe workplace injury
at Trane U.S., Inc., 1255 Vandenberg Dr Ste 138, LITTLE ROCK AIR FORCE BASE, ARKANSAS 72099
on — Fractures and burns, affecting the multiple body parts, n.e.c..
Final narrative
On July 8, 2022 at 9:00 a.m., an employee was removing a flow meter located approximately 8.5 feet off the ground on a heated water system. The building was almost complete, so the heating and chilled water systems were operational. The employee was standing on the second rung from the bottom of the 6-foot A-frame ladder that was placed on a 6-foot concrete pad in the locked position. When the meter probe was removed, 180 F water under pressure struck the employee, causing him to fall backward off the ladder and resulting in a fractured ankle and hot water burns to both arms and his back.
HospitalizedMultiple body parts, n.e.c.Step ladders
The injured employee was holding a pipe while another employee was un-soldering a line. The line split apart and sprayed residual oil on the employee who was holding the pipe. The injured employee sustained second-degree burns to their left hand and arm.
An employee was standing on a ladder drilling a hole in the wall to install the control circuit for a new HVAC system. The employee lost his balance and fell to the ground, resulting in a fracture that required hospitalization.
An employee was dumping trash into a dumpster. The employee fell from the dock into a gap between the dumpster and a bay door, suffering a broken left femur. The employee needed surgery.
An employee was preparing a tank car for loading while chipping away solidified product in the manway opening of the tank car. A pressure noise within the tank car startled the employee, causing him to stumble backward and fall approximately 10 feet over the guard railing at the chemical loading rack to the ground. The employee suffered fractured vertebrae, a fractured right wrist and ankle, and a dislocated jaw.
An employee was installing an electrical tray remover from a ladder. As he was descending, his missed a step and fell 6-7 feet to the floor. The employee suffered a head injury.
Two employees were installing spray foam insulation in the attic of a new residential construction. The injured employee fell 8 feet from an A-frame ladder to the floor. The employee suffered lacerations, abrasions, and a head injury.
An employee was on a raised platform attaching wires to electrical boxes. The employee fell approximately 8 feet to the floor below and struck an exit sign on the way down, resulting in an injury to his face.
An employee was in a forklift man basket fixing a garage door opener when they fell approximately 8 feet to the concrete ground below. The employee suffered head and back injuries as well as kidney bruising.
More severe injuries in this industry (NAICS 333415)
An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.
An employee was observing expansion rods on a coil expander going into a coil to ensure copper stubs weren't being bent. His left hand was caught between the locking block and locking block clamp on the power press machine, resulting in partial amputation of his left little finger from the distal interphalangeal joint.
An employee was setting up a press brake and rolling over a die when the tip of their left little finger was caught between the horizontal working surface of the press brake and die. The employee sustained partial amputation of their fingertip.
An employee was working to remove an access panel to begin performing maintenance on a machine. The set pins on the bottom of the panel were broken. The bottom kicked out and fell, striking the employee's left foot and resulting in a fracture to the big toe.
An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.
On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.
An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.
On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.