Rentokill NA

An employee was passing through a building when she suffered an allergic reaction to a cinnamon air freshener. The employee began to feel dizzy and ill, ultimately becoming unresponsive. The employee was hospitalized.

An employee wearing a blasting hood was preparing to blast inside a tank. The line that supplies the hood with breathing air was plugged into an argon line. The employee breathed the argon gas and fell. The employee was hospitalized for argon poisoning.

An employee was preparing a pump for maintenance. When the employee removed a cover, chemicals were released into the air. The employee was exposed to hydrogen sulfide and methyl mercaptan and was hospitalized.

An employee was exposed to carbon monoxide that was leaking from a kiln. The employee lost consciousness and was hospitalized.

An employee was inside a trailer with a running lawn mower and sustained carbon monoxide poisoning.

The injured employee was trimming a bush with a hedge trimmer. He reached over with his left hand to remove a branch. The blades of the trimmer partially amputated his left index finger.

An employee was performing pest control services at a residential home when he tripped and fell on the front porch steps. The employee was hospitalized with a fractured wrist, two fractured ribs, and a subdural hematoma.

An employee was on a 32-foot fiberglass ladder positioned on a porch roof, using a caulk gun to seal the fascia board around the gable of a house. He was about 16 feet up the ladder, which was not fully extended. The base of the ladder slid away from the house. The employee fell onto the porch roof, then to the ground below, a distance of about 10 feet. He suffered broken ribs, lacerations and facial abrasions, and a potential facial fracture.

An employee was going door-to-door selling pest control services during 80+ degree weather. The employee sustained heat stroke and collapsed.

An employee was performing service on a customer's attic. They stepped off a walk board to retrieve a tool and misstepped onto the rafters, causing them to fall approximately 10 to 12 feet. The employee sustained a back injury.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.

An employee was using a metal shear when it amputated the tip of his right index finger.

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.