Exposure to environmental heat · Heat exhaustion, prostration
At a glance
Federal OSHA recorded a severe workplace injury
at Defense Contract Management Agency, Highland Industrial Park, CAMDEN, ARKANSAS 71701
on — Heat exhaustion, prostration, affecting the bODY SYSTEMS.
Final narrative
An employee had been inspecting ammunition in the heat, wearing flame-retardant coveralls. After leaving for lunch and then returning, he became ill and was hospitalized, suffering from possible heat exhaustion.
HospitalizedBODY SYSTEMSHeat-environmental
More severe injuries at Defense Contract Management Agency
An employee fell in an asphalt parking lot, suffering injuries that caused pain on the left side and a swollen left knee/leg. The employee was hospitalized.
An employee was performing finishing work on a residential driveway when they began to experience body cramps and were hospitalized for heat stress and dehydration.
An agent was participating in SWAT team selection and was performing various physical fitness skills including running and exercise intervals. The agent experienced dehydration and a muscular injury that required hospitalization.
On September 26, 2023, an employee was delivering packages when he began to feel ill with a pain in his side. He was hospitalized for heat exhaustion and dehydration.
More severe injuries in this industry (NAICS 541990)
Employees were conducting a snubbing operation. While making up the tubing swivel onto the joint in the mouse hole, employee 2 proceeded to pull power tongs off the pipe. At the same time, the injured employee went to re-adjust the tong heads. The make/brake handle was pulled and the injured employee's right hand got caught in the tongs. The injured employee's index, middle, and ring fingers were amputated and he required surgery.
On 9/26/2025, an employee was using a pair of scissors to cut a zip-tie that was securing a box of files. The scissors slipped and lacerated the employee s left wrist. The employee was hospitalized.
An employee was troubleshooting and rodding out a piece of process piping equipment when their left index finger was caught between the tool handle and threaded flange. The employee's fingertip was partially amputated.
An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.
On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.
An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.
On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.