Struck against moving part of machinery or equipment · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Pantuck Construction LLC, 15 High St, PHOENIXVILLE, PENNSYLVANIA 19460
on — Amputations, affecting the fingertip(s).
Final narrative
An employee was using a table saw to rip strips of wood when their finger was cut by the blade, resulting in a fingertip amputation.
An employee was operating a strip saw. As the employee shut off the saw, their right index and middle fingertips were amputated by the blade before it came to a complete stop.
An employee was using a table saw to cut a piece of wood for wall framing. The wood jumped, causing the employee's hand to move toward the saw, amputating their left index finger and causing a laceration on their hand.
An employee was operating a trim saw. While trying to free a jammed board she had just cut, she came into contact with the running saw blade, which amputated her right thumb.
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
An employee was on a 6-foot ladder, working to nail a 2-by-4 on a hotel carport ceiling. He lost his balance and his muddy boots slipped. He then fell and his foot lodged in the ladder. His foot was broken in two places and he was hospitalized.
An employee was installing a ceiling joist for a residential home when they fell from a framing structure and landed on the ground 8 feet below. The employee's right arm was fractured.
On September 16, 2025, a employee was moving a dolly with seven drywall sheets. The wheel of the dolly got stuck. The material tipped over and fell onto the employee's left foot, fracturing their tibia.
An employee was installing 80-foot-long trusses onto a 150-foot by 80-foot post-frame building. The employee worked from the north lift and then on the trusses about 20 feet up to install bracing. While installing diagonal bracing on the top chord, the trusses collapsed, causing the employee to fall approximately 20 feet to the concrete and be struck by the falling trusses. The employee was hospitalized with a fractured pelvis and a concussion.
An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.
An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.
An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.
An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.