VESTAVIA HILLS, ALABAMA—
Lee Electrical Construction, LLC
Struck by swinging or slipping object, other than handheld, n.e.c. · Puncture wounds, except gunshot wounds
At a glance
Federal OSHA recorded a severe workplace injury at Lee Electrical Construction, LLC, 2345 Derby Dr, VESTAVIA HILLS, ALABAMA 35216 on — Puncture wounds, except gunshot wounds, affecting the ankle(s).
Final narrative
An employee was descending a power pole using gaffs. At approximately two feet from the ground, the employee stepped down with the left foot, causing the right foot and gaff to dislodge. The right gaff contacted the left ankle resulting in a puncture wound the left ankle.
More severe injuries at Lee Electrical Construction, LLC
WEWAHITCHKA, FLORIDA—
Lee Electrical Construction LLC
An employee was installing a new, non-energized conductor when they contacted the existing conductor and received an electrical shock and burns to their toes.
View Lee Electrical Construction, LLC's full OSHA safety record →
Similar incidents · Same event type
PORTAGE, WISCONSIN—
InterCon Construction, Inc.
A crew was pulling a 4-inch plastic gas pipe off a reel and straightening it for installation. The injured employee stepped up on the trailer to cut the last band holding the pipe in the coil on the reel. As he turned to step off the trailer, the end of the pipe rotated and sprung out of the cage surrounding the coil, striking the employee on the side of the head and knocking him off of the trailer into the roadway. The employee suffered head trauma that required hospitalization.
WYLIE, TEXAS—
RAVA Construction, LLC
An employee and a co-worker were performing a pick inside a clear well. They rigged the skid pan that was full of broken concrete. When lifting, the load began to swing toward a wall. The employee tried to stop the skid pan from swinging and was struck by the pan, resulting in fractures to their left hip and wrist.
MIDDLETOWN, OHIO—
Stein, LLC
The employee had just completed refueling a lattice crane that was breaking up material and was winding the fuel hose back into the fuel truck when he was struck by the catwalk/stairs of the crane. The employee was hospitalized with a laceration to his backside, possible internal bleeding, and a broken hip.
SELMA, TEXAS—
7 Site & Utility, LLC
An employee was fusing 10-inch black rubber utility pipes together using a pipe fusion machine and could not get the pipes to set correctly. The employee used a nylon strap attached to an excavator to lift one side of a pipe off a steel plate. As his hand was between two pipes, the pipes came back together, partially amputating two of his fingers.
STERLING, ILLINOIS—
Sterling Steel Company, LLC
An employee was lifting four bags of a lime blend weighing approximately 10,000 pounds using a crane. The load swung and pinned the employee against a structural I-beam, resulting in fractures to the hip and pelvis.
More severe injuries in this industry (NAICS 238210)
WASHINGTON, DISTRICT OF COLUMBIA—
Smart Building Technologies - A Fidelity Company
An employee was troubleshooting the control setup for a variable air volume box above a ceiling. The employee's hand came into contact with an exposed, energized 277-volt wire that had loosened from its terminal on the box's assembly. He was shocked and fell off a ladder. His left hand passed across the ceiling grid and was lacerated. He also suffered an electrical burn to the right hand and was hospitalized.
CANTON, OHIO—
Abbott Electric Inc
An employee was moving a scissor lift through a doorway. The employee was pinned between the scissor lift and the doorframe, sustained a back injury, and was hospitalized.
AVENTURA, FLORIDA—
Mintcrest Corp
An employee was standing on an A-frame ladder approximately 6 feet above the floor while he attached a suspended light fixture to the ceiling. The employee lost balance, and fell to the tiled floor below, sustaining blunt force trauma to his head.
KUNA, IDAHO—
Cupertino Electric, Inc.
An employee was inspecting the overhead area of a single-person lift and repositioning the lift through a double doorway. As they were transitioning through the doorway, they were caught between the doorframe and the vertical mast of the lift. The employee was hospitalized with injuries to the nose, left maxillary sinus, left orbital bone, and left jaw, with fractures at the maxillary sinus area.
AURORA, ILLINOIS—
Swedberg Electric, LLC
The injured employee was performing routine maintenance on a fan belt/pulley. The injured employee and another person were moving the pulley back and forth manually to find a bearing issue. The injured employee's left ring finger got caught between the belt and the pulley wheel, resulting in a soft tissue amputation.
More severe injuries in ALABAMA
GENEVA, ALABAMA—
Sysco Gulf Coast, LLC
An employee was traveling down the maintenance aisle of a warehouse on a single-pallet front rider jack. The jack malfunctioned, causing the brakes to apply; the employee fell forward onto the concrete warehouse floor. The employee suffered an injury to the left leg and was hospitalized, requiring surgery.
BESSEMER, ALABAMA—
Norflex, Inc.
An employee was operating a metal roller machine to roll a small piece of metal. The employee's right index finger became caught between the metal and the machine, and the fingertip was amputated.
ANNISTON, ALABAMA—
Ampler Pizza II LLC
An employee was shot in the leg with a pistol during an altercation with two people who had entered the store without permission.
ATMORE, ALABAMA—
Birdsong Corporation
An employee was directing a truck driver to a dump site when the truck's peanut trailer slipped off the kingpin. As the trailer fell, a ladder attached to it lacerated the employee's ear. The employee was hospitalized.
ROGERSVILLE, ALABAMA—
Pilgrims
An employee was unloading a forklift from a trailer to the ground. The employee was climbing down the ladder of the trailer when their foot slipped through one of the rungs, causing them to fall backward onto the forklift forks. The employee was hospitalized for fractured ribs.