Caught in running equipment or machinery during maintenance, cleaning · Cuts, lacerations
At a glance
Federal OSHA recorded a severe workplace injury
at Elixir Extrusions, LLC, 1300 Pope Drive, DOUGLAS, GEORGIA 31533
on — Cuts, lacerations, affecting the hand(s), unspecified.
Final narrative
An employee was operating a chassis bender when they noticed oil and began to clean the machine. The employee's right hand was pinned by the mandrel of the bender and the machine, resulting in a contusion and laceration that required stitches.
An employee was pulling metal using a tail stretcher. He pressed the double palm buttons to start the process when the clamp became stuck. The employee pulled on the metal. His left thumb was inside the clamp when it opened, cutting and amputating the tip of his thumb.
An employee was cutting a piece on the finishing saw. They went to grab scraps left after cutting and lacerated their right palm. The employee was hospitalized
Two employees were repairing the hydraulic engagement pins on a rented front-end wheel loader. The machine controls were activated to move the attachment pins and an employee's finger was caught between the pins and the bushings. Their right index finger was partially amputated.
An employee was cleaning the conveyor on a piece of equipment when they slipped and their right hand was pulled into the chain sprocket. The employee's fifth fingertip was amputated.
An employee was throwing blankets onto a blanket folding and stacking machine. A blanket got stuck in the machine and she attempted to remove it when the machine contacted her right little finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 332322)
An employee was driving a forklift when its right front wheel dropped off a 6-inch curb. The forklift rolled over and trapped him against the concrete surface. He suffered a broken pelvis, ribs, and collarbone, as well as a collapsed lung.
An employee was operating a brake press when the top die broke, causing the bottom die to roll out and onto the employee's legs. Both of the employee's legs were crushed below the knee, and both legs were partially amputated. The employee's left leg was also fractured above the knee.
An employee was performing routine maintenance on a shear machine when the machine's foot pedal was engaged and the blade contacted his right middle finger, resulting in a partial amputation.
An employee was helping to tighten down a metal packaging band for shipping. The metal band broke and struck the employee across their face, cutting their left face/eye area. The employee was hospitalized.
An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.
During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.