Bancroft Contracting Corporation

An employee was operating a variable reach forklift to transport an 8" x 8" x 14' timber at a jobsite. The right-side tires entered the grass shoulder at the edge of the road, and the forklift tipped over a three-foot rock dike. The employee sustained a fractured T11 vertebra, and possible fractures to four ribs.

An employee completed a shift during which she moved patient beds and stretchers. While at home, the employee experienced back pain and went to the hospital, where she was diagnosed with spinal fractures.

An employee was lifting and carrying a heavy box. After putting the box down, the employee had back pain and weakness in their left leg. They were hospitalized, having suffered a back sprain.

An employee sustained a lower back strain while assisting a client who was about to fall.

An employee was turning over a patient and felt a pull in her abdomen. The employee sustained a hernia.

An employee was working on the wharf recouping lumber boards (2x4s and 2x6s that can vary from 8' to 16' in length) from bundles that had become misplaced when they sustained a right rotator cuff tear requiring hospitalization.

An employee was cutting cabinet trim using a table saw when four fingers on his left hand were severed, resulting in hospitalization and amputation.

The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.

An employee was installing insulation in a wall when she tripped on a hole (12" deep) and fell, hitting her head on the concrete floor. The employee sustained fractures to her leg and wrist, and lacerations to her head. The employee was hospitalized.

An employee was loading a 4-inch wooden door into a pickup truck when he felt a pop in his right side behind his shoulder blade. He was hospitalized later that day and underwent surgery, having suffered a collapsed right lung.

An employee was operating a power drill when it slipped. The drill bit punctured the employee's hand and they were hospitalized.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.

An employee was using a metal shear when it amputated the tip of his right index finger.

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.