Ergon Refining

An employee was unwiring the secondary side of a de-energized transformer and draining oil for repairs when a wire came loose and shocked the employee. The employee was hospitalized.

An employee was unloading a trailer when a box fell and struck the employee in the face. The employee suffered a concussion and was hospitalized.

An employee had been cutting lumber for a shed wall. A load of 16-foot trim pieces fell onto the employee causing vertebrae and ankle fractures.

An employee was unloading 30-foot 2-inch barrels from a pan holding about 20 barrels. The barrels tipped over, striking and breaking both of the employee's lower legs.

An employee was in a sandblasting area, preparing the surface of a plate heat exchanger frame for painting. The frame fell on the employee, who suffered fractures to vertebrae, the neck, pelvis, and rib cage; and punctured lungs.

An employee was installing doors when one of the doors fell on him, fracturing his lower leg. The employee was hospitalized.

An employee was ascending an 8-foot aluminum extension ladder to access and replace a hypochlorite pump located on top of a 7-foot chemical tank. When he reached approximately 5 feet on the ladder, the ladder shifted and twisted to the right. The employee fell from the ladder and landed on his right side. The employee sustained a compound fracture to his right leg just above the ankle, dislocation of his shoulder, and a torn rotator cuff. The employee was hospitalized.

An employee was taking a butane gas sample as part of the hydrocarbon refining process. A component disconnected and the butane ignited, resulting in first- and second-degree burns to the employee's forearms and to their face, including their cheeks, chin, and neck.

An employee was driving a carry deck/small crane when its boom made contact with an overhead support beam. The employee was jostled in the cab and suffered a concussion.

An employee was inventorying hammer mill screens when the screens fell on the employee. The employee sustained a laceration to their leg requiring hospitalization.

An ironworker was maneuvering a mobile elevated work platform (MEWP) into position to install a structural beam. The employee was pinned between another structural steel beam that was already installed and the MEWP control box cover. The employee was hospitalized with a laceration to their lip, dislodged teeth, and a fractured jaw.

An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.

The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.

An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.

An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.

An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.