Thermal Seal Duct Systems Inc. 4209 N Hwy 77 Frontage Road Ponca City Ok 74601

An employee was operating a band saw when his right little fingertip was amputated.

An employee was operating a strip saw. As the employee shut off the saw, their right index and middle fingertips were amputated by the blade before it came to a complete stop.

An employee was using a table saw to cut a piece of wood for wall framing. The wood jumped, causing the employee's hand to move toward the saw, amputating their left index finger and causing a laceration on their hand.

An employee was operating a trim saw. While trying to free a jammed board she had just cut, she came into contact with the running saw blade, which amputated her right thumb.

An employee was using a shaper to cut wood when their right hand contacted the blade, resulting in a partial amputation to the right ring finger.

The belt on an air compressor had just been put back into place after turning upside down. An employee was working to take a picture of the identifying numbers on the belt so that a replacement could be ordered when the compressor rolled, causing the pulley to spin. The employee's right index finger was caught between the pulley and the belt, and the fingertip was amputated at the first knuckle.

An employee was receiving a 660-pound beverage vending machine for repair. While the machine was being moved from the back of the van to the lift gate, the caster wheel was caught between the van and the lift, causing the machine to fall onto the employee and pin him from the waist down. The employee was hospitalized with three pelvic fractures, a torn left anterior cruciate ligament (ACL), injury to a knee cap, and pain in the lower back/spine.

An employee was debugging/troubleshooting the teach sensor on a load-handling device (LHD) inside of a cell. The LHD unexpectedly moved to the home location and struck the employee on their head. The employee sustained a head injury, an aspiration-induced lung injury, and fractures to his lower back and right ankle.

The injured employee was holding a pipe while another employee was un-soldering a line. The line split apart and sprayed residual oil on the employee who was holding the pipe. The injured employee sustained second-degree burns to their left hand and arm.

An employee was walking through a parking deck to the office when he tripped on a curb and struck his face on a parked truck. The employee was hospitalized for internal injuries and bruising to the right side of the body.

An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.

An employee was working in the food service warehouse when he experienced chest pain, difficulty breathing, and lost consciousness. The employee sustained carbon monoxide poisoning.

An employee was cutting a piece of metal rod with a metal cutting machine. His right middle finger became caught between the rod and the machine's table. The employee's fingertip was partially amputated.

An employee was working at her desk. She went to stand up and fell to the floor beside the desk. The employee sustained a hip displacement and required surgery.

An employee was processing wood boards at a chop saw when the saw malfunctioned and the blade cut her left hand and fingers. She was hospitalized and her little finger was surgically amputated.