Fall on same level due to tripping, unspecified · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Norflex, Inc., 3441 Parkwood Road, BESSEMER, ALABAMA 35022
on — Amputations, affecting the fingertip(s).
Final narrative
An employee was walking around a fabric punch machine to grab a broom and tripped. As he attempted to stop his fall, he grabbed the punch belt with his left hand. His fingers swung on the belt and went across the motor of the punch. He sustained injuries to two fingers on his left hand; the tip of one finger was amputated.
An employee was operating a metal roller machine to roll a small piece of metal. The employee's right index finger became caught between the metal and the machine, and the fingertip was amputated.
An employee was walking down the hall to retrieve a vacuum when they stumbled and fell to the floor. The employee suffered wrist bruises and a kneecap fracture that required surgery.
An employee was installing a compressor piston. He tripped and fell backward while the piston was in his lap. As he landed, the little finger of his left hand became caught between the piston and compressor piping resulting in a partial amputation of the fingertip. The employee required stitches and the fingertip was reattached.
An employee was doing an oil change. He was walking to get his oil jug when he tripped on an open lift pad, and fell to the ground landing on his right side. The employee sustained a broken right femur and was hospitalized.
More severe injuries in this industry (NAICS 327999)
An employee was operating a metal roller machine to roll a small piece of metal. The employee's right index finger became caught between the metal and the machine, and the fingertip was amputated.
An employee was running the cuber machine (moves and stacks blocks onto pallets) in the block plant. He went to manually move some blocks and the carriage of the cuber moved and pinned his midsection (abdomen, pelvis, and lower back region). The employee was hospitalized with fractures to his bottom two ribs and L3 vertebra. The machine was not locked out/tagged out at the time.
An employee opened a butterfly valve on a material hopper control panel and then went to clear a jam. The valve closed on his left hand. His left index and middle fingers were medically amputated above the knuckle.
An employee was opening a curtain on a trailer in preparation to load. When pulling on the strap of the curtain, the strap came loose, and caused the employee to fall on his back. The employee sustained three broken ribs and a subarachnoid hemorrhage. The employee was hospitalized.
An employee was pushing a mineral cart into an oven when the oven door malfunctioned and closed on their right thumb. The employee sustained a partial amputation of the thumb tip.
An employee was traveling down the maintenance aisle of a warehouse on a single-pallet front rider jack. The jack malfunctioned, causing the brakes to apply; the employee fell forward onto the concrete warehouse floor. The employee suffered an injury to the left leg and was hospitalized, requiring surgery.
An employee was operating a metal roller machine to roll a small piece of metal. The employee's right index finger became caught between the metal and the machine, and the fingertip was amputated.
An employee was directing a truck driver to a dump site when the truck's peanut trailer slipped off the kingpin. As the trailer fell, a ladder attached to it lacerated the employee's ear. The employee was hospitalized.
An employee was unloading a forklift from a trailer to the ground. The employee was climbing down the ladder of the trailer when their foot slipped through one of the rungs, causing them to fall backward onto the forklift forks. The employee was hospitalized for fractured ribs.