Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Riceland Foods Inc, 216 North Gee Street, JONESBORO, ARKANSAS 72401
on — Amputations, affecting the fingertip(s).
Final narrative
An employee was wrapping pallets when the pallet wrapper became stuck near the top. The employee was adjusting the photo eye when their right middle fingertip was amputated by the chain and sprocket.
On September 23, 2025, an employee was monitoring a feed roller when they tripped and their right hand contacted the roller. The employee was hospitalized and their right hand was amputated at the wrist.
An employee was riding a manlift up from the ground floor when they fell several feet from the manlift to the floor. The employee sustained a fractured left femur.
An employee was preparing to mount a manlift when it caught their abdomen and pinned the employee between the lift and the wall, lifting him up and wedging him between the lift and the ceiling. The employee sustained abdominal abrasions and contusions as well as a fractured thoracic vertebra.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 311212)
On November 21, 2024, at approximately 7:55 a.m., an employee was getting onto a manlift on the fourth floor while holding two scoop shovels. As he stepped onto the lift, the shovels got caught on the floor, causing him to slip off the step and grab the floor. The employee fell to the concrete third floor, resulting in 4 fractured right ribs and 3 fractured left ribs. He also dislocated his right shoulder.
An employee was riding a manlift up from the ground floor when they fell several feet from the manlift to the floor. The employee sustained a fractured left femur.
An employee was changing out a flex hose at a soaking tank when part of a T-valve burst on the soaking tank, resulting in burns to their torso from the hot water.
An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.
On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.
An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.
On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.