HSG Farms

An employee was using a powered pallet jack to move a fixture. His leg became caught between the pallet jack and the fixture and he fell on the same level, resulting in a fractured left fibula.

An employee was operating a forklift in a warehouse when it began to slide. The forklift was unable to gain traction on the floor that was wet from rain and it slid out of the building and onto the employee's foot. The employee sustained a crush injury to the right foot.

An employee was driving an ATV on a private roadway to respond to a well control event. The employee lost control of the ATV and used their left leg to try and prevent the ATV from flipping over. The employee's left leg was fractured.

An employee was operating a powered industrial truck when it went out of control and pinned his ankle and foot, breaking them.

An employee was mowing the grounds on a rider-mower when he began to feel hip pain and couldn't move.

An employee slipped and his hand got caught in a sprig tumbler as he used it to brace his fall. The employee suffered an amputation of fingers on his left hand and was hospitalized.

On June 17, 2023, around 10:00 AM, an employee was directing a customer who was reversing their pickup truck to get hay from a trailer. The customer's vehicle struck the employee's right leg, fracturing the femur.

An employee was clearing brush on a farming property using an excavator. As the employee exited the excavator, they slipped on the excavator track that was wet from the rain. The employee fell and suffered three fractured ribs that required hospitalization.

An employee was adjusting forklift forks when the forks fell and broke their leg.

An employee was cutting a 55-gallon drum with a torch and the drum exploded. The employee was hospitalized with burns to over 50% of his body.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.

An employee was using a metal shear when it amputated the tip of his right index finger.

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.