Fall from collapsing structure or equipment less than 6 feet · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at E4A Solutions, LLC, 1530 FM 973, TAYLOR, TEXAS 76574
on — Fractures, affecting the shoulder(s), including clavicle(s), scapula(e).
Final narrative
An employee was on a wood platform surrounding a containment wall to work on a transformer. While inspecting the equipment, the wood platform collapsed, causing the employee to fall approximately 4 feet. The employee's shoulder was fractured and required surgery.
HospitalizedShoulder(s), including clavicle(s), scapula(e)Scaffolds-staging, unspecified
An employee was using a two-step step stool to stock product on shelves. The stool collapsed and the employee fell to the ground sustaining a fractured femur.
An employee was walking around and closing up the office for the day. As he was on a table closing the blinds, the table collapsed, causing the employee to fall. He sustained a left kneecap fracture.
Employees were demobilizing a microtunneling operation from inside of a 42-foot shaft. They were standing on a 3-foot high pump stand to disconnect the pump when the pump dropped, and the stand gave way. This caused the employees to slide and fall to the ground. The injured employee fell on his left side, landing on an oil can with his co-worker landing on top of him. The injured employee was hospitalized for a rib fracture.
An employee was standing on a baker's scaffold approximately 3 feet above finished floor to install equipment. While taking measurements, the locking pins came out on one end of the scaffold, causing the scaffold to collapse. The employee fell 3 feet and sustained a left ankle injury.
An employee was troubleshooting the control setup for a variable air volume box above a ceiling. The employee's hand came into contact with an exposed, energized 277-volt wire that had loosened from its terminal on the box's assembly. He was shocked and fell off a ladder. His left hand passed across the ceiling grid and was lacerated. He also suffered an electrical burn to the right hand and was hospitalized.
An employee was moving a scissor lift through a doorway. The employee was pinned between the scissor lift and the doorframe, sustained a back injury, and was hospitalized.
An employee was standing on an A-frame ladder approximately 6 feet above the floor while he attached a suspended light fixture to the ceiling. The employee lost balance, and fell to the tiled floor below, sustaining blunt force trauma to his head.
An employee was inspecting the overhead area of a single-person lift and repositioning the lift through a double doorway. As they were transitioning through the doorway, they were caught between the doorframe and the vertical mast of the lift. The employee was hospitalized with injuries to the nose, left maxillary sinus, left orbital bone, and left jaw, with fractures at the maxillary sinus area.
The injured employee was performing routine maintenance on a fan belt/pulley. The injured employee and another person were moving the pulley back and forth manually to find a bearing issue. The injured employee's left ring finger got caught between the belt and the pulley wheel, resulting in a soft tissue amputation.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.