Federal OSHA recorded a severe workplace injury
at Johnson Controls Fire Protection, LP, 1800 Lombard Street, PHILADELPHIA, PENNSYLVANIA 19146
on — Fractures, affecting the lumbar region.
Final narrative
An employee was completing a sensor replacement on an air-cooled chiller unit and went to sit on a 5-gallon bucket during a rest break. He experienced sudden stiffness in his left knee, causing him to fall backward and strike his back on a pipe hanger. The employee sustained three broken vertebrae in their lower back.
HospitalizedLumbar regionBuckets, baskets, pails
More severe injuries at Johnson Controls Fire Protection, LP
An employee was sitting on a tall teller chair in a bank drive-through. She leaned forward in the chair when it rolled out from under her. As she fell, a metal footstool that was positioned under the teller station was knocked over. The employee fell on top of the footstool and suffered a puncture wound on the right side of her abdomen from one of the metal legs on the footstool.
A switchboard operator leaned back in her chair and the chair tipped over. She fell backward and struck her head on the floor, sustaining a subarachnoid bleed.
The employee had clocked out for the day and was leaving the facility. As the employee was going down an exit ramp to the parking lot, their wheelchair struck a bump and the foot plate became jammed. The employee was ejected from the wheelchair onto the concrete/pavement and sustained a hip fracture.
More severe injuries in this industry (NAICS 238210)
An employee was troubleshooting the control setup for a variable air volume box above a ceiling. The employee's hand came into contact with an exposed, energized 277-volt wire that had loosened from its terminal on the box's assembly. He was shocked and fell off a ladder. His left hand passed across the ceiling grid and was lacerated. He also suffered an electrical burn to the right hand and was hospitalized.
An employee was moving a scissor lift through a doorway. The employee was pinned between the scissor lift and the doorframe, sustained a back injury, and was hospitalized.
An employee was standing on an A-frame ladder approximately 6 feet above the floor while he attached a suspended light fixture to the ceiling. The employee lost balance, and fell to the tiled floor below, sustaining blunt force trauma to his head.
An employee was inspecting the overhead area of a single-person lift and repositioning the lift through a double doorway. As they were transitioning through the doorway, they were caught between the doorframe and the vertical mast of the lift. The employee was hospitalized with injuries to the nose, left maxillary sinus, left orbital bone, and left jaw, with fractures at the maxillary sinus area.
The injured employee was performing routine maintenance on a fan belt/pulley. The injured employee and another person were moving the pulley back and forth manually to find a bearing issue. The injured employee's left ring finger got caught between the belt and the pulley wheel, resulting in a soft tissue amputation.
An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.
An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.
An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.
An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.