Rachel Carson National Wildlife Refuge

An employee was going to the breakroom when they tripped over a chair and fell, resulting in a hip fracture.

An employee arrived at work and was walking into the store through the parking lot. The employee tripped over a curb and fell to the ground, sustaining a femur fracture.

An employee tripped over a box and fell to the floor, fracturing their right arm.

An employee tripped over a piece of angle iron and fell to the floor sustaining a broken hip.

An employee was preparing for a CT scan when she tripped over a loose strap and fell to the floor, fracturing her hip.

On August 21, 2025, an employee was hitching a 20-foot flatbed trailer loaded with a tractor to a pickup truck. As she placed her left fingers near the hitch mechanism to check the remaining distance needed for coupling, the trailer jack dropped into place, contacting her middle and ring fingers. The hitch and ball then made contact with her middle finger. The employee suffered crush injuries to her middle and ring fingers and a fingertip amputation of the middle finger.

An employee was driving an all-terrain vehicle when it rolled over. The employee was ejected and hit the ground, suffering a fracture to their C6 vertebra.

An employee was taking a dog out of a kennel. The dog lunged for the leash and bit the employee's left hand, causing a laceration.

An employee was returning a dog to his kennel after a walk. The dog turned on her and bit her right upper arm, causing lacerations. The employee was hospitalized.

An employee was bitten by a cat, sought medical treatment, and received an antibiotic. The employee had an allergic reaction to the antibiotic and was hospitalized.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.

An employee was using a metal shear when it amputated the tip of his right index finger.

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.