Mayco Manufacturing, LLC

An employee was pouring molten lead into molds. When lead solidifies, the lead is removed from the mold using an eye bolt and chain attached to a bolt that is poured into the lead cylinder. The employee attempted to lift the lead cylinder from the mold, but the mold was stuck to the lead. The employee attempted to clean the surface of the floor underneath the mold using his hand while the mold and lead cylinder were suspended in the air. The mold released from the lead cylinder and struck him in the right thumb, amputating the thumb behind the thumb nail.

An employee was operating a band saw when his right little fingertip was amputated.

An employee was operating a strip saw. As the employee shut off the saw, their right index and middle fingertips were amputated by the blade before it came to a complete stop.

An employee was using a table saw to cut a piece of wood for wall framing. The wood jumped, causing the employee's hand to move toward the saw, amputating their left index finger and causing a laceration on their hand.

An employee was operating a trim saw. While trying to free a jammed board she had just cut, she came into contact with the running saw blade, which amputated her right thumb.

An employee was using a shaper to cut wood when their right hand contacted the blade, resulting in a partial amputation to the right ring finger.

An employee was performing maintenance on the second level of a silo. While they were making sure the belt pulley were not seized up, the belt was powered on, causing the employee's finger to get caught in the sheave. Their left little finger was partially amputated.

A temporary employee was wrapping a chain around a 2,000-pound block of metal, located on the ground. The block tipped over and crushed his right foot. He was hospitalized, requiring surgery.

An employee was observing the clean-up process of a spilled ladle. As the employee was walking away from an area of cooling metal, there was an eruption due to molten metal reacting with water. The employee fell forward, attempted to catch himself, and his right hand touched the molten metal resulting in burns to the little fingertip and middle finger.

An employee was helping unload a skid steer off a truck skip. While positioned with his left foot on the skid steer's step and his right foot on the tire, he was helping unhook the chains from the truck skip and slipped and fell backward, landing on the rear rail of the truck skip. He suffered six broken ribs and a flail chest injury.

While walking down a set of stairs that had four steps, an employee missed a step and slid down the stairs, catching his leg between the upper and lower hand rail. The employee's knee twisted, tearing a thigh muscle.

An employee was traveling down the maintenance aisle of a warehouse on a single-pallet front rider jack. The jack malfunctioned, causing the brakes to apply; the employee fell forward onto the concrete warehouse floor. The employee suffered an injury to the left leg and was hospitalized, requiring surgery.

An employee was operating a metal roller machine to roll a small piece of metal. The employee's right index finger became caught between the metal and the machine, and the fingertip was amputated.

An employee was shot in the leg with a pistol during an altercation with two people who had entered the store without permission.

An employee was directing a truck driver to a dump site when the truck's peanut trailer slipped off the kingpin. As the trailer fell, a ladder attached to it lacerated the employee's ear. The employee was hospitalized.

An employee was unloading a forklift from a trailer to the ground. The employee was climbing down the ladder of the trailer when their foot slipped through one of the rungs, causing them to fall backward onto the forklift forks. The employee was hospitalized for fractured ribs.