North & South Construction Services

An employee was using a saw to cut a piece of concrete when the piece gave way and pushed the saw into the employee's leg. The employee's leg was lacerated, requiring stitches and hospitalization.

An employee was using a utility knife to cut honeycomb paper when the knife amputated their left index fingertip.

An employee was cleaning a resident's chimney. While using a drill, the employee's glove became caught in the drill and their finger was fractured.

An employee was grinding some hardfacing on a bulldozer blade when the 9-inch grinder kicked back and lacerated his left leg above the knee. The employee was hospitalized and required surgery.

An employee was operating a rotating tool to place thread protectors on the end of pipe. Her left hand was on the rotating part of the tool when the tool engaged, resulting in a left forearm fracture and a thumb laceration.

An employee was adjusting the forks on a skid steer when his right index finger got pinched between the forks and the frame of the skid steer. The finger was crushed and required partial amputation of the fingernail area.

An employee was helping to install a marble plank when the plank fell on his hand. His fingers became caught between the plank and the floor, resulting in partial amputations to two fingers.

The injured employee was walking in front of the property by the front door as another employee was removing debris from the roof. The injured employee was struck by a 2 x 4 that was being cleared from the roof. He was knocked unconscious and sustained brain bleeding, as well as head and facial injuries, and required stitches.

An employee had been tasked with hauling large rocks. There was a rock caught in the tailgate of the dump truck that was preventing it from opening. He went to get the rock out and the tailgate came down, crushing his right middle fingertip. The employee sustained a fracture of the distal phalanx and required surgery.

An employee was working in a trench that was 3.5 feet deep when soil fell and hit them, resulting in an injury to their pelvis. The employee was hospitalized.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.

An employee was using a metal shear when it amputated the tip of his right index finger.

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.