Sugarloaf Mountain Corporation

An employee was skiing down a trail when he fell, striking his head on the ground and suffering a concussion with brain bleeding and two broken ribs.

Two ski patrol employees were skiing down a mountain. One of them caught the edge of his ski and fell and struck his head on the ground. He was hospitalized.

An employee was working on skis, removing a fence. The employee fell down onto the trail and suffered a broken hip/pelvis.

An employee slipped while skiing, falling to the ground and suffering a broken pelvis.

An employee was setting up the maze for customers to enter the ski lift area when the employee slipped on ice, breaking the left ankle.

An employee was operating a band saw when his right little fingertip was amputated.

An employee was operating a strip saw. As the employee shut off the saw, their right index and middle fingertips were amputated by the blade before it came to a complete stop.

An employee was using a table saw to cut a piece of wood for wall framing. The wood jumped, causing the employee's hand to move toward the saw, amputating their left index finger and causing a laceration on their hand.

An employee was operating a trim saw. While trying to free a jammed board she had just cut, she came into contact with the running saw blade, which amputated her right thumb.

An employee was using a shaper to cut wood when their right hand contacted the blade, resulting in a partial amputation to the right ring finger.

An employee was trimming tree limbs from a bucket truck. The employee fell from the bucket to the ground 16 feet below, suffering a concussion and a broken rib.

Two employees were in a drive terminal, pulling a new fuel line for an EPU to provide tertiary power for a ski lift. After unspooling the fuel line, one employee took a step backward and fell through the skinning (the floor of the terminal) to the ground about 12-15 feet below. The employee suffered a dislocated ankle and fractures to the lower tibia and fibula.

An employee was doing a sweep of a mountain bike trail when their mountain bike's front tire slipped. The employee fell from the bike to the ground and suffered a broken pelvis. The employee was hospitalized.

An employee was kneeling, lighting the pilot for a gas range, when gas that had leaked from a quick coupler at the back of the range ignited. The employee suffered serious burns to both arms and her neck.

An employee was riding a mountain bike to check on markings and race trails when he struck a tree. He sustained six fractured ribs and a laceration to the spleen.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.

An employee was using a metal shear when it amputated the tip of his right index finger.

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.