Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Gehl Foods, LLC, N116 W15970 Main St, GERMANTOWN, WISCONSIN 53022
on — Amputations, affecting the fingertip(s).
Final narrative
An employee was removing a bottle from a conveyor when their left index fingertip was pinched between the conveyor and a sprocket, resulting in amputation.
A maintenance employee was rebuilding a valve, using air pressure to compress and seat a spring into place. The air pressure came off and the valve spring released. The employee's left-hand fingers were pinched between the spring and valve housing port, partially amputating a fingertip.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 311991)
An employee was painting a wall. They fell down three steps and landed on a plastic mop bucket and the floor. The employee was hospitalized with fractures to their right arm and right hip, and required surgery.
An employee was using an electric jack to load a pallet onto a truck when he was struck from behind by a forklift, resulting in a laceration to his right leg.
An employee was performing maintenance on a tray packer. They put a piece of cardboard down onto the belt of the tray packer and stood on the belt. The belt started, causing the employee to lose balance and fall approximately 2 feet. The employee was hospitalized with a fractured ankle and required surgery.
An employee was adding cilantro to the dicing machine when it became jammed. While clearing the jam, the blade amputated approximately 1/2" to 3/4" of his right middle finger.
An employee was cleaning and sanitizing a mixer when the machine was activated. The employee's hand was caught in the machine and he sustained the amputation of his right hand. The employee was hospitalized.
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.
A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.
An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.
An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.