Hollis Construction Group Inc.

An employee was operating a band saw when his right little fingertip was amputated.

An employee was operating a strip saw. As the employee shut off the saw, their right index and middle fingertips were amputated by the blade before it came to a complete stop.

An employee was using a table saw to cut a piece of wood for wall framing. The wood jumped, causing the employee's hand to move toward the saw, amputating their left index finger and causing a laceration on their hand.

An employee was operating a trim saw. While trying to free a jammed board she had just cut, she came into contact with the running saw blade, which amputated her right thumb.

An employee was using a shaper to cut wood when their right hand contacted the blade, resulting in a partial amputation to the right ring finger.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was on a 6-foot ladder, working to nail a 2-by-4 on a hotel carport ceiling. He lost his balance and his muddy boots slipped. He then fell and his foot lodged in the ladder. His foot was broken in two places and he was hospitalized.

An employee was installing a ceiling joist for a residential home when they fell from a framing structure and landed on the ground 8 feet below. The employee's right arm was fractured.

On September 16, 2025, a employee was moving a dolly with seven drywall sheets. The wheel of the dolly got stuck. The material tipped over and fell onto the employee's left foot, fracturing their tibia.

An employee was installing 80-foot-long trusses onto a 150-foot by 80-foot post-frame building. The employee worked from the north lift and then on the trusses about 20 feet up to install bracing. While installing diagonal bracing on the top chord, the trusses collapsed, causing the employee to fall approximately 20 feet to the concrete and be struck by the falling trusses. The employee was hospitalized with a fractured pelvis and a concussion.

An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.

A casting machine jammed. An employee's hand was caught in the machine, where a belt line caught and amputated the tip of his finger.

During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.

An employee slipped on condensation on a walkway in a parking garage. She fell and suffered a closed fracture to the neck of the left femur.

An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.