Caught in running equipment or machinery, n.e.c. · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Jasper Wyman & Son, 178 Main Street, CHERRYFIELD, MAINE 04622
on — Fractures, affecting the Arm(s), unspecified.
Final narrative
During a sanitation training event, an employee lost his balance. As he was catching himself, his hand contacted an auger and he suffered a broken arm. The guard for the auger had been removed at the time so the employee could demonstrate how to clean it.
Hospitalized Arm(s), unspecified Special process machinery, unspecified
More severe injuries in this industry (NAICS 311411)
An employee was troubleshooting to determine why a pallet was not traveling along a continuous vertical conveyor. The conveyor's rollers caused a crushing/laceration injury to the employee's right hand that required surgery.
An employee was operating a pallet end rider when it struck a rack. The employee's right foot was pinned and fractured between the forklift and the rack.
An employee was putting a machine guard back onto a chain and sprocket when their left middle finger became caught in the chain and sprocket. The employee sustained an amputation of the fingertip.
An employee was changing out a hose on a chemical tote. The fitting for the tote disengaged and the employee was exposed to peracetic acid that caused chemical burns and respiratory distress.
An employee was helping to dismantle an old piece of equipment (descrambled bottle machine) when a metal plate fell and pinched his left middle finger against the wall. The employee sustained a severe laceration that required surgery and amputation.
A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.
Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.
An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.
An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.