Silgan Plastics Corporation

An employee was removing a hot blade from a machine and lacerated three fingers on his right hand and one finger on his left hand. The employee was hospitalized.

An employee changed out a press mold and heated a nozzle with a torch to purge the press out. After the employee was finished heating the nozzle, he went to close the front door when degraded plastic came out of the barrel and onto his right arm. The employee suffered burns to his arm that required hospitalization.

An employee tripped over a stool and fell on the floor, resulting in a left displaced mid-cervical femoral neck fracture.

An employee was installing fence posts when they stepped into a recently dug hole that was not visible due to rainfall. The employee's leg was fractured.

The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.

An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.

An employee tripped over a concrete curb stop in a parking lot. The employee fell to the ground, landing on their left hip and breaking it.

An employee was watching as a technician worked with a machine. The machine's parts were manually moved while the employee's hand was inside the machine, and his fingertip was amputated. The incident took place during a training activity.

On October 14, 2025, an employee was on a step platform showing another employee the support bracket for a blow pin assembly on a blow molding machine that needed repaired. The blow pin assembly came up and pinched the injured employee's right middle finger, resulting in a broken finger and a laceration to the top of the hand.

On August 22, 2025, an employee was helping to move a 700-pound compressor cylinder cap head into position to slide down the bolt holes onto the bottom half of the cylinder. When a bolt hole aligned, his left index fingertip was caught in it. The cap came down and amputated the fingertip.

A maintenance employee was working on a conveyor when his thumb was caught in the chain/sprocket area causing an amputation to the thumb tip. The machine was running at the time of the incident.

On March 20, 2025, at approximately 11:02 AM, an employee was shrink wrapping a pallet when he lost his balance and fell to ground. The employee sustained a hip and leg injury that required hospitalization and surgery.

An employee tripped over a concrete curb stop in a parking lot. The employee fell to the ground, landing on their left hip and breaking it.

An employee was conducting routine maintenance on a mixer. New lid pins had been installed, and the employee was rotating by hand to ensure they had been installed correctly. The employee's left middle finger was caught between the lid and top of a pin. The momentum from the mixer continued, causing a crushing injury to the finger. The employee underwent a medical amputation from the top knuckle to the tip of the finger.

An employee was climbing down a ladder when it slipped. The employee fell, suffering a broken scapula and broken ribs. The employee was hospitalized.

An employee was climbing down a 15-foot multipurpose ladder. The employee fell about 8 feet, landing on the concrete floor and the ladder itself. The employee suffered several injuries, all on the right side: broken ribs, a broken sternum, a broken temporal bone, broken shoulder, multiple fractures to the cheekbone, and a brain bleed.

An employee was rolling up the landing gear on his trailer when the handle began to unwind and struck his face, fracturing his jaw. The employee was hospitalized and required surgery.