Blue Bell Creameries, L. P.

An employee was using an end mill to mill out a section of a metal door frame that he was fabricating. Metal shavings built up and he could not see the marking to cut, so he used a small brush to remove the shavings. While brushing off the shavings, his glove became caught in the spinning mill bit and pulled his hand in. The employee's right index finger contacted the spinning bit, resulting in a partial amputation to the side of the finger.

An employee was exiting the bed of his service truck using the lift gate when he slipped due to the tapered edge and fell, striking the support post of the lift gate. The employee sustained three fractured ribs and cracked vertebrae.

An employee was working from a platform ladder, spraying a tank with water to clean it. The employee slipped; as she tried to steady herself, her right middle finger was caught in a pinch point. The fingertip was amputated and she was hospitalized, requiring surgery.

An employee was changing the battery on a forklift using a mobile battery dolly. The employee positioned the dolly adjacent to the storage rack. The dolly began to roll backward when the employee was transferring the battery and the battery fell off the rack and onto the employee's left foot. Three toes were severely crushed resulting in amputation at the first knuckle.

An employee was moving a stack of empty pallets with an electric pallet jack in a congested area when he tripped and fell. The pallet jack then rolled over his right foot, fracturing it.

An employee was walking through a parking garage. She tripped over a curb and fell forward onto her right knee, then her left knee, both hands, and her face. She suffered an injury to the left knee that required surgery, as well as scrapes on the chin and both palms and soreness in the left wrist.

An employee had been loading packages into a vehicle. While exiting the vehicle, he tripped and fell, fracturing both ankles.

An employee was exiting a train. The employee's foot was caught, and the employee fell, suffering a broken left arm.

An employee was dropping customers off with a shuttle. He stepped out of the shuttle and his foot entered a pothole, causing him to twist his ankle and then fall to the ground. The employee sustained multiple dislocations to the ankle requiring surgery.

An employee was approximately 5 feet up on a ladder while drilling a hole for cable installation. A wasp attacked him. As he was coming down the ladder, he landed flat on his feet on the ground, and his right leg was twisted. The employee sustained a fractured tibia.

An employee was using an end mill to mill out a section of a metal door frame that he was fabricating. Metal shavings built up and he could not see the marking to cut, so he used a small brush to remove the shavings. While brushing off the shavings, his glove became caught in the spinning mill bit and pulled his hand in. The employee's right index finger contacted the spinning bit, resulting in a partial amputation to the side of the finger.

An employee was unjamming cookie dough from a machine when the rotating pump caught her left index and ring fingers, resulting in fingertip amputations.

An employee was marking a malfunctioning mold when their finger got caught between one section of rollers on the mold and the guarding on the next section of rollers. The employee's finger was amputated below the nailbed.

An employee was exiting the rear door of a freezer truck when he slipped/misstepped and fell to the ground. The employee sustained a broken right leg that required surgery.

An employee was palletizing ice cream when his fingers got caught in a chain and sprocket, resulting in amputations of the middle and ring fingers.

An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.

An employee was working in the food service warehouse when he experienced chest pain, difficulty breathing, and lost consciousness. The employee sustained carbon monoxide poisoning.

An employee was cutting a piece of metal rod with a metal cutting machine. His right middle finger became caught between the rod and the machine's table. The employee's fingertip was partially amputated.

An employee was working at her desk. She went to stand up and fell to the floor beside the desk. The employee sustained a hip displacement and required surgery.

An employee was processing wood boards at a chop saw when the saw malfunctioned and the blade cut her left hand and fingers. She was hospitalized and her little finger was surgically amputated.