Walmart Distribution Center #6001

An employee was moving a scissor lift through a doorway. The employee was pinned between the scissor lift and the doorframe, sustained a back injury, and was hospitalized.

A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.

An employee was inspecting the overhead area of a single-person lift and repositioning the lift through a double doorway. As they were transitioning through the doorway, they were caught between the doorframe and the vertical mast of the lift. The employee was hospitalized with injuries to the nose, left maxillary sinus, left orbital bone, and left jaw, with fractures at the maxillary sinus area.

An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.

An employee was operating a stand-up forklift. The forklift drove into a rack in a warehouse, and the employee's right hand was caught between the rack and an upright supporting the forklift's overhead guard. The employee suffered a fracture and laceration to the hand, just below the little finger.

An employee was working to unjam an auger screw. The screw caught his glove, resulting in a severe open fracture to his left lower forearm. He was hospitalized, requiring surgery.

An employee was working in a warehouse without air conditioning on a day when the temperature outside was in the 90s. The employee developed heat stress, became ill, and was hospitalized.

An employee was walking in the middle of the track during heavy rain when he slipped on a rail transition and fell, hitting his arm on the rail. The employee was hospitalized with a fractured left arm.

An employee was scraping down the sides of a mixing machine. The machine activated and her right arm was caught in the auger, resulting in a fractured lower arm.

Two employees were conducting a roll change on a rolling mill machine using a porter bar and a counterweight sleeve. The sleeve slid back and crushed the injured employee's right index fingertip between the sleeve and the counterweight, resulting in a partial amputation.

An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.

On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.

An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.

An employee was helping two other employees to push a pallet of tile on a loading dock. He suffered a broken fibula and was hospitalized.

On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.