Struck by other falling object n.e.c. · Amputations, avulsions, enucleations unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at Kerby Enterprises, Inc., 1 Chemical Plant, RICEBORO, GEORGIA 31323
on — Amputations, avulsions, enucleations unspecified, affecting the Finger or thumb tip(s), nail(s).
Final narrative
An employee was using a come-along hoist to pick up a motor when the hoist slipped and the motor fell, pinching their left little finger resulting in an amputation of the fingertip.
Amputation Finger or thumb tip(s), nail(s) Engine, motor, and mechanical parts n.e.c.
An employee was stacking pallets of sugar when a pallet of sugar that was being transported by a forklift fell onto the employee. They sustained tibia and fibula fractures that required hospitalization.
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.
An employee was attempting to lift a steel beam from a horizontal, stacked position to a vertical position using a crane. They had placed two hooks on the east side of the beam on the flange. As the employee was hoisting the crane, the beam began to shift and pulled the employee forward onto the stack. When the material shifted, the hooks released and the material fell, pinning the employee between the two beams. The employee was hospitalized with soft tissue contusions on their proximal right thigh and interior left thigh.
An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.
An employee's hand was caught in a conveyor belt as they worked to clear a jam in a piece of equipment. The employee suffered a dislocation to the right elbow, as well as a broken ulna near the elbow, and was hospitalized.
An employee was changing AC filters while on a ladder. The employee stepped up to the second-to-last rung when they slipped and fell about 5 feet to the ground. The employee sustained fractures to their scapula and ribs, a collapsed lung, and a back injury.
An employee was performing restoration activities outside a 45-gallon condensation tank of a boiler system. As they were performing post-maintenance activities after repairing one of the two discharge pumps, one of the discharge valves would not open. The employee closed the intake pump to cool off the system and open the discharge valve. Two employees opened the inlet valve to return the tank to service. After they cracked open the inlet valve, a side wall of the tank blew out, causing the injured employee to suffer steam burns to half their body.
On August 19, 2025, an employee became ill and dehydrated after working outdoors for eight hours, participating in training activities. He was hospitalized.
An employee was ascending a fixed ladder and struck his head on an overhead object that was approximately 20 feet above ground level. The employee sustained neck injuries and tingling in his fingers. The employee was hospitalized.
An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.
During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.