Liberty Forge, Inc.

An employee was riding on the side of a forklift. He stepped off the forklift and was struck by the back end of the forklift as it turned to the right. The forklift's back tire ran over his leg, resulting in an amputation. The employee was hospitalized.

An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.

A service crew was pulling a pump and motor from a well. After breaking a joint of pipe loose from another joint, an employee grabbed the chain tongs to prevent the pipe from spinning in the well, so the crew could continue taking it apart. The bolt that attaches the chain to the handle of the chain tongs broke, causing the chain to swing around and strike the employee's lower right leg. The chain severely punctured his leg and fractured his tibia.

An employee was using a handheld grinder to cut a bolt. The grinding wheel broke apart and a fragment struck the employee s right hand, causing a laceration to the palm near the little finger.

An employee was operating a brake press when the top die broke, causing the bottom die to roll out and onto the employee's legs. Both of the employee's legs were crushed below the knee, and both legs were partially amputated. The employee's left leg was also fractured above the knee.

A pressurized aircraft nose landing gear strut assembly was being disassembled. The gland nut dislodged under pressure and made contact with an employee's left hand, breaking it.

An employee was riding on the side of a forklift. He stepped off the forklift and was struck by the back end of the forklift as it turned to the right. The forklift's back tire ran over his leg, resulting in an amputation. The employee was hospitalized.

An employee was loading a nozzle, weighing approximately 500 pounds, onto a positioner. The stainless steel nozzle slipped off the positioner and struck the employee's right leg. The employee's right tibia was fractured and their left knee was bruised.

An employee was preparing a hammer and dies for operation. The ram prop was inserted in the hammer to secure the ram. While the employee went to apply grease to the die shim in the hammer, the ram moved downward. The motion dislodged the prop, causing the ram to drop and crush the employee's right hand and forearm. The employee sustained amputations to their hand and arm and was hospitalized.

An employee was doing a tool changeover on a table mill and changing the mandrel. His hands were on both wrenches with his right thumb was between the two wrenches as he worked to unlock the mandrel. The wrenches came together, crushing his thumb. The employee was hospitalized with a partial amputation of the thumb.

An employee was helping to remove tooling that was stuck in a forging press (a full-revolution mechanical power press). The press cycled, resulting in partial amputations to two fingers on his left hand.

After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.

An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.

An employee was inspecting flares processes. The employee received burns to the front side of the body, face and arm from the flares.

An employee was removing plastic material from a production line when the machine cycled and amputated his left index, ring, and little fingers.

An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.