Federal OSHA recorded a severe workplace injury
at V and H Material Handling, Cemecon Inc, HORSEHEADS, NEW YORK 14845
on — Fractures , affecting the Skull.
Final narrative
A crew was dismantling an automated storage unit. A piece of the unit fell on an employee's head, causing a laceration and a skull fracture. The employee was hospitalized.
Hospitalized Skull Vehicle and machine parts unspecified
An employee was walking past a crossover conveyor when a ramp came down and hit them in the back. The employee sustained a broken back vertebra, as well as a concussion, and was hospitalized.
An employee was unloading frameless mirrors from a trailer. When unstrapped, the mirrors fell over onto the employee, who suffered a skull fracture, a brain bleed and blood clot, a broken left ankle, and lacerations.
A temporary employee was rigging secondary steel when the steel joist fell to the ground and struck his lower left leg, resulting in fractures to the tibia and fibula.
Two maintenance employees were dismantling a machine part (steel cylindrical rollers) on the ground. After unbolting a portion, part of the assembly fell approximately 6 inches onto one employee's left little finger. The employee was hospitalized and about 3/4" of their little finger above the top joint was surgically amputated.
An employee was pulling a data cable through a ceiling. He fell through the ceiling, landing at ground level. He suffered a laceration to the forehead, a dislocated left little finger, a broken left ring finger, and a laceration to the liver.
On September 16, 2025, an employee was installing and adjusting spotlights on a performance stage that was under construction. While crossing the stage to speak with other contractors, the employee encountered a section of the stage where the elevation changed to a lower level. As the employee stepped down 14 inches to the lower level, his knee locked up and he fell to the stage. He subsequently rolled off the stage and fell approximately 2 to 3 feet to the floor, resulting in a fractured tibial plateau in his right leg.
An employee was delivering a 65-foot boom lift to a rental customer's construction site. The employee set up the ramp truck in the parking lot adjacent to the construction site. He elevated the boom 4-5 feet to clear a temporary fence. While driving the boom lift off the ramp, the wheels slid to the driver's side of the ramp truck, ultimately sliding off the ramp. The boom lift fell off the side of the truck and rolled onto its side. The employee sustained a fractured clavicle, a dislocated shoulder, separated/fractured ribs, a punctured lung, and a fractured left femur. The employee required surgery.
An employee was performing maintenance on a telehandler and installing a carriage lift cylinder. The employee was checking the alignment when the cylinder slipped and partially amputated his left middle finger.
An employee had just serviced a battery and was reinstalling it in a forklift using a battery extractor. The employee was trying to pull the battery out of the battery compartment when the extractor moved, causing the battery to shift on the rollers. The employee's right hand was crushed between the top of the battery and the battery compartment.
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
An employee slipped while descending in a stairwell, fell, and suffered multiple contusions/bruises to the head, neck, shoulders, knees, and back. She was hospitalized.
An employee was directing trucks as they entered and left a highway work zone. A vehicle struck them, resulting in multiple fractures and other injuries. The employee was hospitalized.