OUTLAW TRAILER CONVERSIONS

An employee was climbing a 6-foot A-frame ladder when it gave way, became unbalanced, and fell over. He then fell and hit his head on the concrete below, suffering a head injury.

An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.

A service crew was pulling a pump and motor from a well. After breaking a joint of pipe loose from another joint, an employee grabbed the chain tongs to prevent the pipe from spinning in the well, so the crew could continue taking it apart. The bolt that attaches the chain to the handle of the chain tongs broke, causing the chain to swing around and strike the employee's lower right leg. The chain severely punctured his leg and fractured his tibia.

An employee was using a handheld grinder to cut a bolt. The grinding wheel broke apart and a fragment struck the employee s right hand, causing a laceration to the palm near the little finger.

An employee was operating a brake press when the top die broke, causing the bottom die to roll out and onto the employee's legs. Both of the employee's legs were crushed below the knee, and both legs were partially amputated. The employee's left leg was also fractured above the knee.

A pressurized aircraft nose landing gear strut assembly was being disassembled. The gland nut dislodged under pressure and made contact with an employee's left hand, breaking it.

An employee was kneeling on his left knee with his right knee up while taking measurements of a car he was working on. As he switched knees, and put his right knee on the ground with his left knee up, his right hip dislocated and he bent forward onto his hands. The employee was hospitalized and required hip surgery.

An employee was finishing up using a resistance welder on a vehicle. After finishing, he removed his gloves and picked up the resistance welding arm with his left hand on the hydraulic cylinder and his right hand on the handle. The button on the handle was activated and the hydraulic cylinder engaged, catching the tip of his left little finger and resulting in a fingertip amputation.

An employee was working to attach a safety handle to the cable portion of a pulley system designed to aid in the operation of a resistance welder. The tension on the cable was disengaged, then reengaged while the employee's left hand was on the top of the pulley system. The cable caught the tip of the employee's left little finger, causing an amputation at the first joint.

At about 8:00 a.m. on August 8, 2025, an employee was holding a metal coupon for another employee to use in demonstrating spot-welding technique to a third, student employee. A metal hole puncher was activated and crushed the employee's left middle finger, resulting in an amputation to the finger. The incident occurred during a training activity.

An employee was closing the gate at the end of the day when it missed a latch and came off its track. The gate fell onto him, resulting in hospitalization with a fractured femur that required surgery.

After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.

An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.

An employee was inspecting flares processes. The employee received burns to the front side of the body, face and arm from the flares.

An employee was removing plastic material from a production line when the machine cycled and amputated his left index, ring, and little fingers.

An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.