Fall on same level resulting in exposure or contact · Amputations involving bone loss
At a glance
Federal OSHA recorded a severe workplace injury
at G&S Lumber Co., Inc., 291 S US Highway 59, NACOGDOCHES, TEXAS 75963
on — Amputations involving bone loss, affecting the Upper arm(s).
Final narrative
An employee was unjamming crooked logs, slipped on wet metal tracks, and fell backward into a 58" diameter saw blade that was rotating at 840 revolutions per minute. The employee sustained an amputation of his left arm, just above the elbow.
A sanitation employee entered the chemical room and slipped on the wet floor. When he slipped, he kicked over a bucket containing cleaning chemicals. The chemicals splashed onto the employee's clothing and burned his skin.
An employee tripped while walking from one store register station to another. Her forehead struck a register, and she suffered fractures to two vertebrae in her neck. She was hospitalized.
An employee was using an electric pallet jack to retrieve a chemical tote from a staging lane. He inserted the pallet jack under the tote and began to back up. After moving backward for approximately 15 feet, the employee tripped on a collapsible tote. As he fell, the pallet jack ran over his left foot. His ankle was lacerated and his foot was fractured.
An employee had been unloading tires from the back of a pickup truck. The employee went to step down out of the back of the pickup truck and stepped on the lift gate in a vertical position. The lift gate tipped and employee fell, impacting their side on the upright liftgate. The employee sustained five fractured ribs and a punctured right lung. The employee was hospitalized.
An employee was repairing a photo eye on the infeed roll case when they dropped a tool. The employee went to grab the tool and his fingers contacted the chain and sprocket of the infeed roll case. His fingers were pulled into the pinch point and the fingertips were crushed, resulting in amputation of one fingertip.
An employee was troubleshooting dispersing equipment. A belt and pulley system was energized, and the moving belt caught the employee's right ring finger. He suffered a partial amputation at the first knuckle, below the nail.
An employee was cleaning the photo eye sensors of a piece of equipment between the saw that cuts lumber into lengths and boards. The employee stepped on a metal grate that gave way and fell 8-10 feet. The employee was able to remove himself from the conveyor. His tibia was fractured just below the knee.
While refilling a lubricant tank, an employee observed that a pump was not operating correctly. While troubleshooting the issue, the employee reached toward the back of the pump to check for proper airflow. Their left index finger contacted moving components in the pump's piston mechanism, resulting in partial amputation of the fingertip.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.