Vital Steel Erectors, Inc.

The injured employee was helping another employee put a clamp on an I-beam that was attached to a crane. When the crane began to lift the load, the I-beam tipped to the left and caught the injured employee's left leg against another I-beam. The employee was hospitalized with crush injuries to his left tibia and fibula and required surgery.

An employee was getting down from a roof using a scissor lift when he fell 30 feet to the base of the lift scissor mechanism, suffering internal bleeding, kidney damage and multiple fractures to both legs that required hospitalization.

An employee was laying glue on the corner of a three-story commercial flat roof to apply new thermoplastic polyolefin roofing material. He lost his balance and fell at least 35 feet to the concrete ground below. The employee sustained fractures.

An employee was blasting a water tower. They fell approximately 60 feet off a suspended scaffold and sustained broken vertebrae, a compound fracture of the tibia, a fractured heel, and a rupture to their liver. The employee was hospitalized.

An employee was working to install overhead brackets for bridge construction. They went to move a generator and fell 38-feet from the bridge deck that was under construction. The employee sustained fractures to their hip, right femur, left wrist, and ankle.

An employee was climbing down a tree after setting a rope to allow the tree to be removed. A knot at the end of his climbing system failed and he fell from the tree, landing about 35 feet below. He suffered fractures to the pelvis and spinal cord and was hospitalized.

An employee was painting in the middle section of a tower when she fell 70 feet through the hatch. The employee was hospitalized with arm fractures.

An employee fell from a step ladder while reaching for a tie-off point. He impacted the ground, and landed on his bolt bag which contained tools. The employee was hospitalized with fractured ribs, and a lacerated spleen and kidney.

An employee was attempting to lift a steel beam from a horizontal, stacked position to a vertical position using a crane. They had placed two hooks on the east side of the beam on the flange. As the employee was hoisting the crane, the beam began to shift and pulled the employee forward onto the stack. When the material shifted, the hooks released and the material fell, pinning the employee between the two beams. The employee was hospitalized with soft tissue contusions on their proximal right thigh and interior left thigh.

An employee was standing on the surface of a steel beam about two feet wide. He slipped and fell backward, landing on the concrete ground about 20 feet below. The employee sustained a broken pelvis.

An employee was unloading a rebar delivery from a flatbed, 19-wheel trailer. The employee rigged the load with wire rope chokers. The load was picked up 3-4 feet above the trailer deck by a crane. The load began to swing and the employee grabbed onto it to prevent it from being pushed off the trailer deck. The crane continued to lift the load, and the employee let go so the crane did not lift him to the third story. The employee fell approximately 12 feet to the ground below, resulting in a back injury and fractured vertebrae.

An employee was attaching a steel angle plate weighing (approximately 200 pounds) to the end of a structural member (5,000 pounds) and was supported by dunnage. The dunnage was a crane mat (11 inches tall) with a 4x6 board on top of it and it supported five identical members. The main piece was 30.75 feet long, 37.25 feet tall, and 1 food wide. As the employee slid the piece of metal on top of the member to begin attaching it, the entire member began to tip over. The employee went to stop the main piece from tipping over and it landed on his ankle, fracturing it.

After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.

An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.

An employee was inspecting flares processes. The employee received burns to the front side of the body, face and arm from the flares.

An employee was removing plastic material from a production line when the machine cycled and amputated his left index, ring, and little fingers.

An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.