Other fall to lower level 6 to 30 feet · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Cameron Building Envelope Specialist, 1595 Tondorf Rd, WASHINGTON, DISTRICT OF COLUMBIA 20057
on — Fractures , affecting the Multiple body parts n.e.c..
Final narrative
An employee was working on the outrigger platform of a mast climber when he fell approximately 30 feet from the fifth floor down to the second level of the courtyard. The employee sustained fractures to the right side of his ribs and his right arm and leg.
Hospitalized Multiple body parts n.e.c. Self-supporting scaffolds or staging
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
An employee was standing on the surface of a steel beam about two feet wide. He slipped and fell backward, landing on the concrete ground about 20 feet below. The employee sustained a broken pelvis.
An employee was cleaning out an inlet pipe in a stormwater structure. The employee stepped back, fell into the pipe, and landed on concrete 13 feet below, at the bottom of the structure. He suffered a broken back.
An employee was working on a platform, raised 6 to 8 feet in the air, to get something off a rack. The employee fell from the platform to the ground and sustained a head injury and injury to multiple body parts.
An employee was preparing to unjam an auger shaft while standing on a forklift-elevated, job-made platform. The employee's wrench slipped off the equipment, causing them to lose their balance and fall. The employee landed on the ground 14 feet below and suffered fractures to the orbital bone, left elbow, and lower back.
More severe injuries in this industry (NAICS 238310)
An employee was closing a rear trailer door in the parking lot when they were struck by a forklift. The employee's lower left leg was crushed between the pallet on the forklift and the trailer. The employee sustained muscle damage to their lower leg.
An employee was cutting wood with a circular saw. The machine lagged and cut the employee's finger. The employee required surgical amputation of the finger at the hospital.
An employee was climbing a 12-foot ladder when he lost his balance and fell from the eighth rung to the ground. He sustained multiple broken ribs, which caused lung punctures.
An employee was installing spray-on fire proofing from a scissor lift. The scissor lift tipped over and the employee fell, resulting in multiple fractures to their leg, shoulder, and skull.
An employee was troubleshooting the control setup for a variable air volume box above a ceiling. The employee's hand came into contact with an exposed, energized 277-volt wire that had loosened from its terminal on the box's assembly. He was shocked and fell off a ladder. His left hand passed across the ceiling grid and was lacerated. He also suffered an electrical burn to the right hand and was hospitalized.
An employee was assembling a baker type scaffold. He was beginning to transverse down the scaffold, approximately six feet off the ground, when the scaffold tipped over and he fell. The employee was hospitalized with a fractured femur.
An employee was stocking and ordering the meat case on the sales floor when he slipped and fell due to water on the floor. The employee was hospitalized with a fractured ankle and required surgery.
An employee was working on an exhaust fan on the roof when he tripped on a wire and fell to the ground. The employee sustained scrapes on his elbow, and a fractured right knee with a torn ACL. The employee was hospitalized.