Other fall to lower level 6 to 30 feet · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Sun Mountain Lumber, 181 Greenhouse Rd, DEER LODGE, MONTANA 59722
on — Fractures , affecting the Multiple trunk locations.
Final narrative
A truck driver climbed the ladder on the back of his chipper truck to check the level of product loaded. He slipped and fell 13-14 feet to the hard-packed dirt and gravel ground. His pelvis and lower back vertebrae were fractured. The employee was hospitalized.
Hospitalized Multiple trunk locations Trucks with other mounted machinery, equipment n.e.c.
An employee was using his left arm to pull a piece of lumber from a chain, which was on his right side, to stack it on a lumber bunk positioned to his left. His left middle fingertip was crushed between the end of the lumber he was moving and the stationary lumber stack behind him, resulting in an amputation.
An employee was reaching for a broken piece of lumber that was hung up on a board edger's infeed chains. His right hand was caught between two cants (or a cant and part of the machinery); the hand was lacerated and the index, middle, ring, and little fingers were broken.
An employee was attempting to clear a piece of wood stuck under the guard of a cabinet defect saw. The saw activated and amputated the right middle and ring fingers at the first knuckle.
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
An employee was standing on the surface of a steel beam about two feet wide. He slipped and fell backward, landing on the concrete ground about 20 feet below. The employee sustained a broken pelvis.
An employee was cleaning out an inlet pipe in a stormwater structure. The employee stepped back, fell into the pipe, and landed on concrete 13 feet below, at the bottom of the structure. He suffered a broken back.
An employee was working on a platform, raised 6 to 8 feet in the air, to get something off a rack. The employee fell from the platform to the ground and sustained a head injury and injury to multiple body parts.
An employee was preparing to unjam an auger shaft while standing on a forklift-elevated, job-made platform. The employee's wrench slipped off the equipment, causing them to lose their balance and fall. The employee landed on the ground 14 feet below and suffered fractures to the orbital bone, left elbow, and lower back.
More severe injuries in this industry (NAICS 321113)
An employee was repairing a photo eye on the infeed roll case when they dropped a tool. The employee went to grab the tool and his fingers contacted the chain and sprocket of the infeed roll case. His fingers were pulled into the pinch point and the fingertips were crushed, resulting in amputation of one fingertip.
An employee was troubleshooting dispersing equipment. A belt and pulley system was energized, and the moving belt caught the employee's right ring finger. He suffered a partial amputation at the first knuckle, below the nail.
An employee was cleaning the photo eye sensors of a piece of equipment between the saw that cuts lumber into lengths and boards. The employee stepped on a metal grate that gave way and fell 8-10 feet. The employee was able to remove himself from the conveyor. His tibia was fractured just below the knee.
While refilling a lubricant tank, an employee observed that a pump was not operating correctly. While troubleshooting the issue, the employee reached toward the back of the pump to check for proper airflow. Their left index finger contacted moving components in the pump's piston mechanism, resulting in partial amputation of the fingertip.
An employee was fixing an issue with seed cleaning equipment when he slipped on the ladder he was on. He went to catch himself and his hand went into a moving belt and pulley on the cleaner. The employee sustained the amputation of his right middle and index fingertips just below the fingernails.
An employee was riding an all-terrain vehicle (ATV) to move a bison herd. He was riding up the side of a steep hill when the ATV struck a rock and rolled, ejecting the employee before rolling over him. The employee suffered broken vertebrae in his back that required hospitalization.
An employee was climbing in the spreader area to remove a pasta jam when his right little finger was cut by the rotary cut-off knife. The employee sustained a laceration and fracture, resulting in an amputation.
A smoke jumper parachuted out of a helicopter during a forest fire response, landed on steep rugged terrain, and suffered femur and rib fractures and a liver laceration. The employee was hospitalized.