Valley Pallet and Crating, LLC

A security officer was following a suspected shoplifter who got into their SUV. The employee jumped onto the side footrail of the SUV when the suspect began to drive away. The employee stayed on the vehicle for several blocks until he jumped off. When the employee jumped off, he landed on his feet then fell to the ground hitting his head on the ground. The employee sustained dislocated left index finger, subdural hematoma/head injury, tibia/fibula fractures to the right leg which required surgical repair.

On 7/05/2025, an employee was involved in a verbal confrontation with a customer at the check-out area. Later, in the parking lot, the customer drove her vehicle toward the employee, hitting his leg. The employee sustained a fractured leg.

An employee was walking in the parking lot while on a break when they were struck by a vehicle, resulting in a head and leg injury.

An employee was washing dishes when hot water spilled onto them. The employee suffered second-degree burns to the neck and back.

On October 17, 2024, an employee was washing dishes when another employee threw hot water onto them, burning their chest and neck.

An employee was cutting wood with a miter saw when their clothing was pulled into the blade, resulting in a bicep laceration. The employee was hospitalized. The blade cover was not in place at the time of the incident.

Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.

An employee was processing wood boards at a chop saw when the saw malfunctioned and the blade cut her left hand and fingers. She was hospitalized and her little finger was surgically amputated.

An employee was operating a bubble wrap production line. He was splicing the ends of the film rolls together with tape when a driven roll contacted his hand. His hand and arm were pulled into the machine up to his shoulder. The employee's forearm contacted the the hot surface (230-500 F) of the bubble stamping cylinder. He was hospitalized with burns to the forearm that required surgery and crushing injuries to the hand and forearm without fractures.

An employee was operating a pallet dismantling saw. A board became stuck, and the employee tried to pull the pallet. When the board broke, the employee's right hand made contact with the blade, resulting in the amputation of the right middle finger above the second knuckle.

An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.

A casting machine jammed. An employee's hand was caught in the machine, where a belt line caught and amputated the tip of his finger.

During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.

An employee slipped on condensation on a walkway in a parking garage. She fell and suffered a closed fracture to the neck of the left femur.

An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.