Nestle Purina - Hartwell, GA

An employee was clearing a metal pallet that was stuck on a filler line when a sensor triggered and the filler actuated, pinning the employee between the machine and the base layer of the pallet. The employee suffered four broken vertebrae and a fractured sternum.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.

An employee was attempting to lift a steel beam from a horizontal, stacked position to a vertical position using a crane. They had placed two hooks on the east side of the beam on the flange. As the employee was hoisting the crane, the beam began to shift and pulled the employee forward onto the stack. When the material shifted, the hooks released and the material fell, pinning the employee between the two beams. The employee was hospitalized with soft tissue contusions on their proximal right thigh and interior left thigh.

An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.

An employee was rigging I-beams. An I-beam slid off the stack of I-beams and fractured the employee's leg.

An employee was working on removing the gearbox from the drive shaft of the motor assembly of a feather drier. He was using a hydraulic tool to pull the pieces apart when a bolt dislodged from the eye of the gearbox and the corner of the gearbox broke off. The employee was struck in the nose (sinus cavity), resulting in hospitalization and surgery.

An employee was on a forklift checking the sprinkler system drain. The employee fell 8 feet from the forklift to the floor. The employee suffered a broken collar bone and was hospitalized.

An employee was working as a dumper on a packaging line. A passing forklift turned and pinned the employee against a guardrail. The employee suffered fractures to their ribs and a leg requiring hospitalization.

An employee was cleaning an upper mezzanine. When he leaned against the mezzanine gate, he fell through the gate opening and landed 11 feet below. The employee sustained fractured orbital bones.

An employee was assigned to clean a feed mill in the basement. He then rode a tool and material basket to return from the basement to the ground level. He fell out of the basket and landed about 5 feet below. The employee sustained fractures to his arm, lower back, and foot.

An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.

A casting machine jammed. An employee's hand was caught in the machine, where a belt line caught and amputated the tip of his finger.

During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.

An employee slipped on condensation on a walkway in a parking garage. She fell and suffered a closed fracture to the neck of the left femur.

An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.