Other fall to lower level unspecified · Cuts, lacerations, punctures without injury to internal structures
At a glance
Federal OSHA recorded a severe workplace injury
at Carroll Materials, 25 Doles Ridge Road, LIMERICK, MAINE 04048
on — Cuts, lacerations, punctures without injury to internal structures, affecting the Other finger(s) n.e.c..
Final narrative
An employee was standing on a ladder while unwinding a hose on a cement mixer. The employee slipped and fell and their left ring finger got caught between a tank and a sight glass as they were falling. A ring on their finger was then crushed into the finger, resulting in a deep laceration.
Hospitalized Other finger(s) n.e.c. Cement and concrete mixer trucks
An employee was retrieving a Christmas tree from a shelf using a ladder. He missed a step and fell to the concrete floor. He sustained injury to his head and wrist.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee fell from a step ladder while reaching for a tie-off point. He impacted the ground, and landed on his bolt bag which contained tools. The employee was hospitalized with fractured ribs, and a lacerated spleen and kidney.
An employee slipped while descending in a stairwell, fell, and suffered multiple contusions/bruises to the head, neck, shoulders, knees, and back. She was hospitalized.
More severe injuries in this industry (NAICS 423390)
An employee was helping to install a tarp on a roof when they fell through a skylight to the ground below, resulting in fractures to their face and ribs.
On August 5, 2025, an employee was exiting a room when his left middle and ring fingers became caught in the door as it shut. The middle fingertip was amputated.
An employee was driving a forklift and unloading racks of glass from a truck. A rack began to tilt; the employee exited the forklift and went to stabilize it. The rack tipped and pinned his left arm against the forklift. The forearm was broken and required surgery.
An employee was working to tow a forklift with another forklift when the tow line came loose and struck their face. The employee sustained head, face, and eye injuries.
A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.
Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.
An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.
An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.