KUBOTA MANUFACTURING OF AMERICA CORPORATION

An employee was walking through a parking garage. She tripped over a curb and fell forward onto her right knee, then her left knee, both hands, and her face. She suffered an injury to the left knee that required surgery, as well as scrapes on the chin and both palms and soreness in the left wrist.

An employee had been loading packages into a vehicle. While exiting the vehicle, he tripped and fell, fracturing both ankles.

An employee was exiting a train. The employee's foot was caught, and the employee fell, suffering a broken left arm.

An employee was dropping customers off with a shuttle. He stepped out of the shuttle and his foot entered a pothole, causing him to twist his ankle and then fall to the ground. The employee sustained multiple dislocations to the ankle requiring surgery.

An employee was approximately 5 feet up on a ladder while drilling a hole for cable installation. A wasp attacked him. As he was coming down the ladder, he landed flat on his feet on the ground, and his right leg was twisted. The employee sustained a fractured tibia.

At 12:55 p.m. on October 8, 2025, a pneumatic cylinder press was activated while an employee's hand was resting on it. The moving shaft and top portion of the machine descended, catching the employee's right middle finger and amputating the fingertip (without bone loss).

An employee had been providing lawncare service and was driving back to the main facility when he experienced severe cramping due to heat stress. The employee was hospitalized for dehydration.

At about 5:15 p.m. on June 14, 2025, an employee was using a walk-behind mower to mow middle islands along a road. A support truck with an arrow board sign was following behind to control traffic. The truck lurched forward and struck the employee from behind, pinning the employee against the mower. The employee suffered a fractured hip, a right iliac wing fracture, right femoral nerve damage, and puncture wounds to the right leg. The employee was hospitalized.

A welder in the fabrication shop was straightening a wheel tab with a hammer and struck his left hand. The employee was hospitalized with a fractured hand.

A sprayer boom assembly fell off a sawhorse when the C-clamp was removed and it struck an employee. The employee suffered a separated collarbone and three broken ribs.

An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.

A casting machine jammed. An employee's hand was caught in the machine, where a belt line caught and amputated the tip of his finger.

During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.

An employee slipped on condensation on a walkway in a parking garage. She fell and suffered a closed fracture to the neck of the left femur.

An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.