Weisinger Inc.

An employee was pulling pipe when the employee became ill, requiring hospitalization for possible heat stress.

An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.

A service crew was pulling a pump and motor from a well. After breaking a joint of pipe loose from another joint, an employee grabbed the chain tongs to prevent the pipe from spinning in the well, so the crew could continue taking it apart. The bolt that attaches the chain to the handle of the chain tongs broke, causing the chain to swing around and strike the employee's lower right leg. The chain severely punctured his leg and fractured his tibia.

An employee was using a handheld grinder to cut a bolt. The grinding wheel broke apart and a fragment struck the employee s right hand, causing a laceration to the palm near the little finger.

An employee was operating a brake press when the top die broke, causing the bottom die to roll out and onto the employee's legs. Both of the employee's legs were crushed below the knee, and both legs were partially amputated. The employee's left leg was also fractured above the knee.

A pressurized aircraft nose landing gear strut assembly was being disassembled. The gland nut dislodged under pressure and made contact with an employee's left hand, breaking it.

An employee was replacing a water check valve at a water plant. He was lifting the valve with two hands when it slipped and contacted his right ring finger, resulting in a partial amputation without bone loss.

The injured employee was assisting with hitching a trailer to a truck. The employee was working to engage the lunette ring on the trailer with the pintle hook on the truck. A mini-excavator began driving onto the rear of the trailer. The added weight caused the rear of the trailer to lower and the front to rise, creating a pinch point between the trailer and the truck. The employee s left thumb was caught in the latch mechanism of the pintle hook. The thumb tip was partially amputated and required surgery.

An employee was spraying down an area by a conveyor he had been using. Moving parts (such as rollers and chains) inside a gear box amputated his right arm at the elbow. The employee was hospitalized.

An employee was adjusting a machine attached to a tractor that rolls out hose into a trench. The machine lowered to the ground and part of it landed on his big toe, amputating it.

An employee was stung by a bee while working in the field. The employee suffered an allergic reaction and was hospitalized.

After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.

An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.

An employee was inspecting flares processes. The employee received burns to the front side of the body, face and arm from the flares.

An employee was removing plastic material from a production line when the machine cycled and amputated his left index, ring, and little fingers.

An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.