EMCOR Government Services Inc.

An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.

An employee was standing on the surface of a steel beam about two feet wide. He slipped and fell backward, landing on the concrete ground about 20 feet below. The employee sustained a broken pelvis.

An employee was cleaning out an inlet pipe in a stormwater structure. The employee stepped back, fell into the pipe, and landed on concrete 13 feet below, at the bottom of the structure. He suffered a broken back.

An employee was working on a platform, raised 6 to 8 feet in the air, to get something off a rack. The employee fell from the platform to the ground and sustained a head injury and injury to multiple body parts.

An employee was preparing to unjam an auger shaft while standing on a forklift-elevated, job-made platform. The employee's wrench slipped off the equipment, causing them to lose their balance and fall. The employee landed on the ground 14 feet below and suffered fractures to the orbital bone, left elbow, and lower back.

An employee's hand was caught in a conveyor belt as they worked to clear a jam in a piece of equipment. The employee suffered a dislocation to the right elbow, as well as a broken ulna near the elbow, and was hospitalized.

An employee was changing AC filters while on a ladder. The employee stepped up to the second-to-last rung when they slipped and fell about 5 feet to the ground. The employee sustained fractures to their scapula and ribs, a collapsed lung, and a back injury.

An employee was performing restoration activities outside a 45-gallon condensation tank of a boiler system. As they were performing post-maintenance activities after repairing one of the two discharge pumps, one of the discharge valves would not open. The employee closed the intake pump to cool off the system and open the discharge valve. Two employees opened the inlet valve to return the tank to service. After they cracked open the inlet valve, a side wall of the tank blew out, causing the injured employee to suffer steam burns to half their body.

On August 19, 2025, an employee became ill and dehydrated after working outdoors for eight hours, participating in training activities. He was hospitalized.

An employee was ascending a fixed ladder and struck his head on an overhead object that was approximately 20 feet above ground level. The employee sustained neck injuries and tingling in his fingers. The employee was hospitalized.

An employee was closing a gun locker in his automobile trunk when his left middle finger was partially amputated by the lid.

An employee was ascending a flight of stairs after exiting their vehicle in an adjacent employee parking lot. The employee stepped to the right to avoid another employee on the left who was descending the stairs. The employee lost their balance and fell on the stairs. They were hospitalized with a laceration/abrasion to their chin, a fractured left humerus, and bruising to their left knee.

A mail handler was moving BMCs on the loading dock when they fell from the loading dock to the concrete ground below. The employee was hospitalized with head trauma.

An employee was on an A-frame ladder while preforming demolition of a ceiling. A section of HVAC ductwork fell on the employee and knocked them to the ground approximately 12 feet below. The employee was hospitalized with a concussion and lacerations.

On the morning of July 24, 2025, an employee was conducting synthesis of a highly toxic experimental chemical (nerve agent) in a chemical fume hood. The operation was completed at approximately 11:30 AM. The employee was exposed to the chemical and began experiencing symptoms of illness/poisoning around 1:30 PM and was hospitalized.