Fall to lower level from collapsing structure or equipment 6 to 30 feet · Intracranial injuries unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at AJ Reyes Construction LLC, Lot 34 catalina ct, NEWNAN, GEORGIA 30263
on — Intracranial injuries unspecified , affecting the Brain.
Final narrative
On April 1, 2025, an employee was setting trusses. When he repositioned himself on another area of the structure, he stepped on an unsecured truss and fell 11 feet and 6 inches to the concrete surface, and sustained head and brain injuries. Fall protection was in place at the time.
An employee was delivering materials. He was doing his pre-delivery inspection on the roof of the jobsite (a warehouse) when he fell through a plexiglass skylight. He landed on his feet on the concrete floor 14 feet below. The employee sustained fractures to his spine, left ulnar/radius, and right heel. The employee required surgery.
An employee was climbing a ladder to inspect a vent in a restaurant dining area. The ladder slid out on the floor and the employee fell approximately 12 feet onto the ladder and the floor. He was hospitalized with a dislocated shoulder and a back injury.
An employee was standing on a multi-purpose ladder installing head flashing over a window. Their feet were approximately 6 feet off the ground and three rungs from the top. The employee lost their grip on the drill they were using and the ladder tipped over. The employee fell from the ladder to the ground, resulting in a fractured left wrist, bruised chest, and lacerations to their face and lip.
An employee was assembling a baker type scaffold. He was beginning to transverse down the scaffold, approximately six feet off the ground, when the scaffold tipped over and he fell. The employee was hospitalized with a fractured femur.
An employee was working from an extension ladder, installing a security camera. The ladder fell out from under the employee, who fell to the ground 12 feet below and broke his right femur.
More severe injuries in this industry (NAICS 238130)
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
An employee was on a 6-foot ladder, working to nail a 2-by-4 on a hotel carport ceiling. He lost his balance and his muddy boots slipped. He then fell and his foot lodged in the ladder. His foot was broken in two places and he was hospitalized.
An employee was installing a ceiling joist for a residential home when they fell from a framing structure and landed on the ground 8 feet below. The employee's right arm was fractured.
On September 16, 2025, a employee was moving a dolly with seven drywall sheets. The wheel of the dolly got stuck. The material tipped over and fell onto the employee's left foot, fracturing their tibia.
An employee was installing 80-foot-long trusses onto a 150-foot by 80-foot post-frame building. The employee worked from the north lift and then on the trusses about 20 feet up to install bracing. While installing diagonal bracing on the top chord, the trusses collapsed, causing the employee to fall approximately 20 feet to the concrete and be struck by the falling trusses. The employee was hospitalized with a fractured pelvis and a concussion.
An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.
During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.