Video Pipe Inspection, Inc.

An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.

A service crew was pulling a pump and motor from a well. After breaking a joint of pipe loose from another joint, an employee grabbed the chain tongs to prevent the pipe from spinning in the well, so the crew could continue taking it apart. The bolt that attaches the chain to the handle of the chain tongs broke, causing the chain to swing around and strike the employee's lower right leg. The chain severely punctured his leg and fractured his tibia.

An employee was using a handheld grinder to cut a bolt. The grinding wheel broke apart and a fragment struck the employee s right hand, causing a laceration to the palm near the little finger.

An employee was operating a brake press when the top die broke, causing the bottom die to roll out and onto the employee's legs. Both of the employee's legs were crushed below the knee, and both legs were partially amputated. The employee's left leg was also fractured above the knee.

A pressurized aircraft nose landing gear strut assembly was being disassembled. The gland nut dislodged under pressure and made contact with an employee's left hand, breaking it.

Employees were conducting a snubbing operation. While making up the tubing swivel onto the joint in the mouse hole, employee 2 proceeded to pull power tongs off the pipe. At the same time, the injured employee went to re-adjust the tong heads. The make/brake handle was pulled and the injured employee's right hand got caught in the tongs. The injured employee's index, middle, and ring fingers were amputated and he required surgery.

On 9/26/2025, an employee was using a pair of scissors to cut a zip-tie that was securing a box of files. The scissors slipped and lacerated the employee s left wrist. The employee was hospitalized.

An employee had been taking fuel samples from the top of a barge. The employee was hospitalized with heat exhaustion.

An employee was troubleshooting and rodding out a piece of process piping equipment when their left index finger was caught between the tool handle and threaded flange. The employee's fingertip was partially amputated.

An employee was walking in steel-toed boots when his left foot struck a pallet jack, resulting in partial amputation of a toe.

A driver was exiting his vehicle outside the plant gate when his foot slipped on the top step of the truck. He fell to the ground, landed on his left hip and elbow. The employee was hospitalized with a fractured hip/femur.

A security employee was responding to an urgent call from staff regarding a violent patient. The employee tripped and fell on the floor outside of the stairwell. The employee sustained a closed head injury, contusion of the cerebrum without loss of consciousness, and a closed fracture of the distal end of the right radius.

A security employee was holstering her firearm when the gun discharged a bullet into her right leg. The employee was hospitalized.

A temporary employee was testing an electrical starter motor. He was placing tape on the starter while the breaker was not engaged, but the starter sent an arc flash that burned his hands and stomach.

An employee was walking on a sidewalk and stubbed his toe on an elevated portion of concrete, causing him to trip and fall. The employee's right knee was dislocated.