Fall, contact incident onboard water vehicle · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Tri-State Maritime Services, Inc., 900 Alabama State Docks Blvd, MOBILE, ALABAMA 36601
on — Fractures , affecting the Hip joint(s).
Final narrative
An employee was lining up steel coils in the hold of a vessel when a coil shifted, pinning the employee between the coil and the wall of the vessel. The employee sustained a fractured hip.
Hospitalized Hip joint(s) Water vehicle unspecified
More severe injuries at Tri-State Maritime Services, Inc.
An employee was operating a forklift when it struck another forklift. The employee was ejected, then caught under the second forklift. His left hand was amputated and he suffered two collapsed lungs.
An employee was preparing a barge for the end of a day's drilling operations. He was setting a spud on the barge when the spud struck him and broke his right leg.
A team of employees was moving boats from one slip in a marina to another using rope. An employee slipped while moving around in a boat and suffered a broken left femur.
The injured employee was standing by the controls for the electric spud system on the barge, preparing to raise the spuds. Meanwhile, an excavator was moving a mat on the deck. As the excavator swung from port to starboard, it's counterweight struck the injured employee s shoulder, causing them to lose balance and fall against the spud controls. The employee sustained bruises and contusions to their right shoulder and chest.
An employee was inserting dogbone links (4 feet 9 inches in length) into the slots between sectional barges to connect the barges. A dogbone link became stuck in the slot and needed to slide down approximately 1 foot to be seated. The employee went to lift the dogbone link up and adjust it when the link became free. A burr on the flange of the link snagged the employee's right glove. The link slid into a seated position and the employee's right middle finger was caught between the top surface of the barge and the top flange of the dogbone link. The finger was partially amputated at the midsection of the distal phalanx.
While preparing to install a new spool piece for a vapor and spent sulfuric acid line, an employee was working to ensure there was no residual product or pressure in the line before removing the 6-inch hose. The valve was cracked, and some spent acid still in the line sprayed out. The employee was standing off to the side and at a distance, but was still contacted by the hot acid, resulting in corrosive and thermal burns to their upper torso and mid-thighs of both legs.
An employee was driving a utility tractor rig when it struck the rear trailer of another utility tractor rig, which was traveling in the opposite direction. The glancing impact caused damage to the cab, and he sustained a laceration on right side of his face, a cervical fracture, two fractured left ribs, and a pelvic fracture. The employee was hospitalized.
The injured employee was standing by the controls for the electric spud system on the barge, preparing to raise the spuds. Meanwhile, an excavator was moving a mat on the deck. As the excavator swung from port to starboard, it's counterweight struck the injured employee s shoulder, causing them to lose balance and fall against the spud controls. The employee sustained bruises and contusions to their right shoulder and chest.
An employee was standing on the outside edge of a hopper barge while watching a skid steer push ore for an excavator (with a clamshell bucket) to unload. The excavator was on a work barge. The bucket of the excavator struck the employee and caused a near-amputation of their right arm and fractures of the ulna and radius of the left arm. The right arm required surgery.
An employee was inspecting a conveyor to see why it was not running. The employee entered the the conveyor motor area, tripped on a piece of angle iron welded to the floor, and fell. The employee sustained a fractured orbital bone.
An employee was traveling down the maintenance aisle of a warehouse on a single-pallet front rider jack. The jack malfunctioned, causing the brakes to apply; the employee fell forward onto the concrete warehouse floor. The employee suffered an injury to the left leg and was hospitalized, requiring surgery.
An employee was operating a metal roller machine to roll a small piece of metal. The employee's right index finger became caught between the metal and the machine, and the fingertip was amputated.
An employee was directing a truck driver to a dump site when the truck's peanut trailer slipped off the kingpin. As the trailer fell, a ladder attached to it lacerated the employee's ear. The employee was hospitalized.
An employee was unloading a forklift from a trailer to the ground. The employee was climbing down the ladder of the trailer when their foot slipped through one of the rungs, causing them to fall backward onto the forklift forks. The employee was hospitalized for fractured ribs.