105,313Records 71,083Employers 85,290Hospitalizations 27,770Amputations 2015-01-01 2025-10-31
Safety Incidents OSHA Severe Injury Reports · 2015–2025

Haas Sons, Inc.

Struck by running powered equipment irregular movement, kick back · Cuts, lacerations, punctures without injury to internal structures

Federal OSHA recorded a severe workplace injury at Haas Sons, Inc., Near the intersection of Co. Hwy's H and K, GRANTON, WISCONSIN 54436 on — Cuts, lacerations, punctures without injury to internal structures, affecting the Upper arm(s).

On May 23, 2025, at approximately 4:15 PM, an employee was operating a cut-off saw to cut a section of 18-inch diameter concrete storm pipe in preparation for installation. The blade became pinched and kicked back, striking the employee in the left bicep. The employee sustained a laceration to the bicep that required surgery.

Hospitalized Upper arm(s) Saws except chainsaws

Haas Sons, Inc.

On April 15, 2025, an employee was operating a cut-off saw to cut a section of 12" precast concrete storm pipe in preparation for installation and suffered a cut to the front of the neck. The employee was hospitalized.

View Haas Sons, Inc.'s full OSHA safety record →

Champion Replacement Windows of Kansas City

An employee was cutting a board using a circular saw. The saw pinched, kicked back, and cut the employee's left ring and little fingers. The employee suffered an amputation to the little finger.

Jamestown Metal Marine Sales, Inc.

An employee was cutting wood with a circular saw. The saw kicked back, and its blade cut three fingers on the employee's right hand, resulting in an amputation.

Oschner Clinic Foundation

An employee was using a table saw to cut wedges for a deck when the wood jumped and his right palm was lacerated by the blade.

Menard, Inc.

An employee was doing a cutback on a piece of lumber using a chop saw. The saw hit a knot, the piece of lumber buckled, then kicked back and broke the kickback guard. The board was then pulled back into the blade, which lacerated the employee's left index and middle fingers.

FC Drywall

An employee was cutting wood with a circular saw. The machine lagged and cut the employee's finger. The employee required surgical amputation of the finger at the hospital.

Simon Contractors of South Dakota, Inc.

An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.

Cypress Gulf Development Corp.

An employee fell while stepping off the tailgate of a pickup truck. The employee landed on the ground and suffered a broken left fibula and tibia.

Circle H Contractors, LP

On October 7, 2025, employees were conducting trenching operations for the installation of a new sewer line system. The excavator's bucket was detached and put inside the trench as it was being exchanged for a different-sized bucket. An employee entered the trench with a shovel to move some dirt located at the front end of the pipe. The excavator bucket shifted and slid, striking the employee s right foot and trapping it against the ground. The employee sustained a fractured right tibia.

WPM-Southern, LLC

Employees were working to dislodge a large truck that was stuck in a rut using tow straps and a front-end loader with the bucket removed. An employee connected the straps to the loader and truck and another employee slowly engaged the loader to close the coupler. The injured employee's arm became caught in a pinch point. The employee was hospitalized with a fractured arm.

Garrison Enterprise Inc.

An employee was lifting a piece of 30-inch line stopping equipment using a jack screw. A lifting eye weld snapped and the load dropped. The end of the jack screw then landed on the employee's heel and crushed it. The employee was hospitalized.

RG Professional Carpenter, Inc.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

General Thermodynamics, Inc.

An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.

Sargento Foods Inc

A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.

Asher Enterprises, Inc.

An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.

Consolidated Electrical Distributors Inc.

An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.