Hayward Laboratories, Inc.

An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.

A service crew was pulling a pump and motor from a well. After breaking a joint of pipe loose from another joint, an employee grabbed the chain tongs to prevent the pipe from spinning in the well, so the crew could continue taking it apart. The bolt that attaches the chain to the handle of the chain tongs broke, causing the chain to swing around and strike the employee's lower right leg. The chain severely punctured his leg and fractured his tibia.

An employee was using a handheld grinder to cut a bolt. The grinding wheel broke apart and a fragment struck the employee s right hand, causing a laceration to the palm near the little finger.

An employee was operating a brake press when the top die broke, causing the bottom die to roll out and onto the employee's legs. Both of the employee's legs were crushed below the knee, and both legs were partially amputated. The employee's left leg was also fractured above the knee.

A pressurized aircraft nose landing gear strut assembly was being disassembled. The gland nut dislodged under pressure and made contact with an employee's left hand, breaking it.

A temporary employee was cleaning the outside of a cylinder on a cream filling machine. The machine had been turned on so that leftover product could drain from it. The paper towel the employee was using fell into the cylinder, and as the employee went to retrieve it, the blade inside the cylinder amputated the tip of his right middle finger.

An employee was operating a ride-on powered pallet jack when his left calf was pinned between the pallet jack and a bollard. He was hospitalized with a laceration to the calf.

An employee was troubleshooting a capper machine that places caps onto cosmetic containers. His left hand was pulled into the machine, resulting in an injury to his middle finger and a ring finger amputation.

An employee was cleaning the heads of a crimper with a paper towel when the machine caught the paper towel and her right glove. The middle and ring fingers were amputated.

On April 25, 2023, an employee was using a machine that fills sachets with hair care products. The blade activated while she was feeding film into the cutting area and amputated her right middle fingertip without bone loss and lacerated her right index finger.

An employee was closing a door when the door closed on their right index finger, resulting in a fingertip amputation.

An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.

An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.

An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.

An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.