Seven Islands Land Company

An employee was mowing a residential lawn at a client's house. The mower slid on the land and tipped over onto him. The employee was hospitalized with a fractured vertebra in the neck and partial paralysis.

An employee was driving a forklift when its right front wheel dropped off a 6-inch curb. The forklift rolled over and trapped him against the concrete surface. He suffered a broken pelvis, ribs, and collarbone, as well as a collapsed lung.

An employee was operating a utility task vehicle (UTV). During a left turn, the vehicle rolled over on its right side. The employee suffered a lumbar strain and fractures to four lower-back vertebrae. She was hospitalized.

An employee was loading a telehandler onto a trailer and the right wheels were misaligned with the trailer, causing the telehandler to tip and fall to the right. The employee went to exit the telehandler as it fell, striking his head on the cage and frame of the telehandler. The employee sustained a concussion, a head laceration, and fractured vertebrae.

An employee was driving an ATV when it overturned and rolled onto its side. The employee sustained a fractured elbow requiring hospitalization and surgery.

A contracted employee was strapping a truck when they were struck by the skidder blade as it was being lowered to the ground, resulting in a broken left leg and injuries to the right leg that required hospitalization.

On November 22, 2022, an employee was helping the operator of a pop-up chop saw by removing cut stock. The employee made contact with the sawblade, suffering an amputation to the left middle finger.

An employee was operating a road grader. The grader stopped and the employee dismounted to check it. The grader then began moving. The employee chased it down and jumped up to stop it, but fell under it. The employee suffered a broken right leg.

An employee was trying to start a chipper when the chipper exploded, causing second degree burns to the employee's face, neck, and arms.

An employee severely lacerated the palm of his hand after coming into contact with a chipper blade. The chipper was not running at the time.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.

An employee was using a metal shear when it amputated the tip of his right index finger.

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.